[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Bug#502550: marked as done (Fail to boot)

Your message dated Fri, 19 Feb 2010 17:07:49 +0100
with message-id <20100219160749.GB1667@inutil.org>
and subject line Re: Kernel Parameter 'nosmp' makes the cow fly
has caused the Debian Bug report #502550,
regarding Fail to boot
to be marked as done.

This means that you claim that the problem has been dealt with.
If this is not the case it is now your responsibility to reopen the
Bug report if necessary, and/or fix the problem forthwith.

(NB: If you are a system administrator and have no idea what this
message is talking about, this may indicate a serious mail system
misconfiguration somewhere. Please contact owner@bugs.debian.org
immediately.)


-- 
502550: http://bugs.debian.org/cgi-bin/bugreport.cgi?bug=502550
Debian Bug Tracking System
Contact owner@bugs.debian.org with problems
--- Begin Message --- 
Package: installation-reports

Boot method: CD netinst
Image version: http://cdimage.debian.org/cdimage/daily-builds/daily/arch-latest/i386/iso-cd/debian-testing-i386-netinst.iso
Date: 16. October 2008 ca 18:00

Machine: Packard Bell Easynote MH45-U-100GE
Processor: Intel Pentium Dual Core T3200 2.0 GHz
Memory: 3 GB
Partitions: two ntfs, one ext 3 as /, one Swap

Output of lspci -knn (or lspci -nn):
How can I submit this in rescue mode?

Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it

Initial boot:           [O]
Detect network card:    [O]
Configure network:      [O]
Detect CD:              [O]
Load installer modules: [O]
Detect hard drives:     [O]
Partition hard drives:  [O]
Install base system:    [O]
Clock/timezone setup:   [O]
User/password setup:    [O]
Install tasks:          [O]
Install boot loader:    [O]
Overall install:        [E]

Comments/Problems:
Install ok (I used the daily image as the official ones did not recognize CD and/or network, probably due to new Hardwarenetwork is a Realtek 8102E)
but System does not boot. During start system hangs without any response. CPUs are recognized, then nothing happens.

Booting the rescue system from CD again work without problems.

Last screen output when booting in the single User mode is:
ACPI: LNXTHERM01 is registered as thermal_zone0

During installation everything seemed ok. Why does the system boot from CD but not from Harddisk?

Regards,
Peter

--- End Message ---
--- Begin Message --- 
peter@zorbas.de wrote:
> Hi Moritz,
> 
> sorry for not updating the bug, In the meanwhile, the problem is solved, the laptop runs without nosmp on both CPUs. 
> If I remember right, I tried after a BIOS upgrade and it worked. Not 100% sure if this was the solution or updates from your side, as I did not try at every boot without nosmp.

Ok, closing the bug, then.

Cheers,
        Moritz

--- End Message ---
Reply to: