--- Begin Message ---
- To: submit@bugs.debian.org
- Subject: Lenny Beta II + daily build, kernel dies after initrd.gz....ready.
- From: Hans-Joachim Zierke <Usenetspam013@Zierke.com>
- Date: Thu, 30 Oct 2008 15:43:38 +0100
- Message-id: <1225377818l.25033l.1l@Odysseus>
Package: Installation-reports
Boot method: Booted from CD
The following is copied from Etch dmesg
sym0: <810a> rev 0x12 at pci 0000:00:0c.0 irq 11
sym0: No NVRAM, ID 7, Fast-10, SE, parity checking
sym0: SCSI BUS has been reset.
scsi0 : sym-2.2.3
Vendor: PLEXTOR Model: CD-ROM PX-40TS Rev: 1.01
Type: CD-ROM ANSI SCSI revision: 02
target0:0:1: Beginning Domain Validation
target0:0:1: asynchronous
target0:0:1: FAST-10 SCSI 10.0 MB/s ST (100 ns, offset 8)
BIOS is SDMS 4.12.0.0, and reports "No Emulation" mode on
BIOS screen while booting.
Image version: 157034496 2008-10-28 22:11 debian-LennyBeta2-i386-netinst.iso
Second try with daily build
debian-testing-i386-netinst.iso
from
http://cdimage.debian.org/cdimage/daily-builds/daily/arch-latest/i386/iso-cd/
But it is also reproducible with a Knoppix CD, and
therefore probably a general Isolinux problem not
limited to the Debian Installer.
Date: Oct 29
Machine: Homebuilt 24/7 machine, motherboard ASUS A7V 1.04 with
latest BIOS 1011 from 2002, running under Debian Etch
normally.
SCSI controller is an ASUS SC-200,
SDMS BIOS 4.12.0.0 is delivered by the motherboard, as usual
for these controllers.
Processor: Duron 600
CPU: After generic identify, caps: 0183f9ff c1c7f9ff 00000000 00000000 00000000 00000000 00000000
CPU: After vendor identify, caps: 0183f9ff c1c7f9ff 00000000 00000000 00000000 00000000 00000000
CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line)
CPU: L2 Cache: 64K (64 bytes/line)
CPU: After all inits, caps: 0183f9ff c1c7f9ff 00000000 00000420 00000000 00000000 00000000
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: AMD Duron(tm) Processor stepping 00
Checking 'hlt' instruction... OK.
Memory: SDRAM 100
383MB LOWMEM available.
Partitions: Filesystem Type 1K-blocks Used Available Use% Mounted on
/dev/hda1 ext3 21342047 4444456 15813206 22% /
tmpfs tmpfs 193452 0 193452 0% /lib/init/rw
udev tmpfs 10240 84 10156 1% /dev
tmpfs tmpfs 193452 8 193444 1% /dev/shm
/dev/hdc2 ext3 91658564 44736272 42266256 52% /home
/dev/hde1 ext3 476750548 341159516 111373448 76% /home/hajo/Archiv
/dev/hdf1 ext3 240362656 143533616 84619240 63% /home/hajo/Archiv/Bahn
Output of lspci -knn (or lspci -nn):
00:00.0 Host bridge [0600]: VIA Technologies, Inc. VT8363/8365 [KT133/KM133] [1106:0305] (rev 02)
00:01.0 PCI bridge [0604]: VIA Technologies, Inc. VT8363/8365 [KT133/KM133 AGP] [1106:8305]
00:04.0 ISA bridge [0601]: VIA Technologies, Inc. VT82C686 [Apollo Super South] [1106:0686] (rev 22)
00:04.1 IDE interface [0101]: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE [1106:0571] (rev 10)
00:04.2 USB Controller [0c03]: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller [1106:3038] (rev 10)
00:04.3 USB Controller [0c03]: VIA Technologies, Inc. VT82xxxxx UHCI USB 1.1 Controller [1106:3038] (rev 10)
00:04.4 Bridge [0680]: VIA Technologies, Inc. VT82C686 [Apollo Super ACPI] [1106:3057] (rev 30)
00:09.0 Multimedia video controller [0400]: Brooktree Corporation Bt878 Video Capture [109e:036e] (rev 02)
00:09.1 Multimedia controller [0480]: Brooktree Corporation Bt878 Audio Capture [109e:0878] (rev 02)
00:0a.0 Multimedia controller [0480]: Philips Semiconductors TriMedia TM-1300 [1131:5402] (rev 83)
00:0b.0 PCI bridge [0604]: IBM IBM27-82351 [1014:0022] (rev 01)
00:0c.0 SCSI storage controller [0100]: LSI Logic / Symbios Logic 53c810 [1000:0001] (rev 12)
00:0d.0 Multimedia audio controller [0401]: C-Media Electronics Inc CM8738 [13f6:0111] (rev 10)
00:11.0 Mass storage controller [0180]: Promise Technology, Inc. PDC20265 (FastTrak100 Lite/Ultra100) [105a:0d30] (rev 02)
01:00.0 VGA compatible controller [0300]: Matrox Graphics, Inc. MGA G400/G450 [102b:0525] (rev 04)
02:00.0 Network controller [0280]: Compaq Computer Corporation Netelligent Dual 10/100 TX PCI UTP [0e11:ae40] (rev 10)
02:01.0 Network controller [0280]: Compaq Computer Corporation Netelligent Dual 10/100 TX PCI UTP [0e11:ae40] (rev 10)
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot: [E]
Detect network card: [ ]
Configure network: [ ]
Detect CD: [ ]
Load installer modules: [ ]
Detect hard drives: [ ]
Partition hard drives: [ ]
Install base system: [ ]
Clock/timezone setup: [ ]
User/password setup: [ ]
Install tasks: [ ]
Install boot loader: [ ]
Overall install: [ ]
Comments/Problems:
BIOS boot uneventful, Hostadapter BIOS reports "No Emulation" mode,
Installation CD screen comes up fine with all the help options. After
<Enter>, I get
Loading /something-386/vmlinuz .....................
Loading /something-386/initrd.gz .......................................
.........................ready.
After that, the machine stops activity, nothing even after 10 minutes,
and does not react to Ctrl-Alt-Del. Hardware reset necessary.
I also tried with Kernel boot parameters "noapic nolapic acpi=off" with
the same results. After the Lenny II Beta, I tried with another CD from
daily build, and I also tried with Knoppix. Knoppix gives the same
result to ...........ready, just with different naming for kernel and
initrd.
--- End Message ---
--- Begin Message ---
On Sat, Aug 22, 2009 at 12:36:01AM +0200, Moritz Muehlenhoff wrote:
> On Wed, Nov 05, 2008 at 10:10:54PM +0100, Frans Pop wrote:
> > reassign 504016 linux-2.6
> > thanks
> >
>
> Hans-Joachim, did you try later versions of the installer on this
> system? Did any of them succeed?
Submitter's address bounces, closing.
Cheers,
Moritz
--- End Message ---