Bug#480763: marked as done (linux-2.6: disable CONFIG_PRISM54)
Your message dated Wed, 14 May 2008 17:18:23 +0200
with message-id <20080514151823.GE13196@stro.at>
and subject line Re: Bug#480763: linux-2.6: disable CONFIG_PRISM54
has caused the Debian Bug report #480763,
regarding linux-2.6: disable CONFIG_PRISM54
to be marked as done.
This means that you claim that the problem has been dealt with.
If this is not the case it is now your responsibility to reopen the
Bug report if necessary, and/or fix the problem forthwith.
(NB: If you are a system administrator and have no idea what this
message is talking about, this may indicate a serious mail system
misconfiguration somewhere. Please contact owner@bugs.debian.org
immediately.)
--
480763: http://bugs.debian.org/cgi-bin/bugreport.cgi?bug=480763
Debian Bug Tracking System
Contact owner@bugs.debian.org with problems
--- Begin Message ---
Package: linux-2.6
Version: 2.6.25-1
Severity: normal
CONFIG_PRISM54 was disabled in 2.6.24 but it's back again in 2.6.25. It
should be disabled because the new mac80211-based P54 driver replaces
it.
This causes problems for me because my wlan card is matched by both
p54pci and prism54's modaliases; this makes udev loads the wrong one,
so I have to blacklist prism54 by hand.
-- System Information:
Debian Release: lenny/sid
APT prefers testing
APT policy: (530, 'testing'), (520, 'unstable'), (510, 'experimental')
Architecture: i386 (i686)
Kernel: Linux 2.6.25-1-686 (SMP w/1 CPU core)
Locale: LANG=en_GB.UTF-8, LC_CTYPE=en_GB.UTF-8 (charmap=UTF-8)
Shell: /bin/sh linked to /bin/bash
--- End Message ---
--- Begin Message ---
Version: 2.6.25-3
On Mon, 12 May 2008, Sam Morris wrote:
> Package: linux-2.6
> Version: 2.6.25-1
> Severity: normal
>
> CONFIG_PRISM54 was disabled in 2.6.24 but it's back again in 2.6.25. It
> should be disabled because the new mac80211-based P54 driver replaces
> it.
urrgs, thanks for catching it. fixed with 2.6.25-3 in incoming.
seem to have forgotten to add bug closure.
pasting changelog:
---
linux-2.6 (2.6.25-3) unstable; urgency=low
.
[ Bastian Blank ]
* Add stable release 2.6.25.3:
- sit: Add missing kfree_skb() on pskb_may_pull() failure.
- sparc: Fix mmap VA span checking.
- CRYPTO: eseqiv: Fix off-by-one encryption
- CRYPTO: authenc: Fix async crypto crash in crypto_authenc_genicv()
- CRYPTO: cryptd: Correct kzalloc error test
- CRYPTO: api: Fix scatterwalk_sg_chain
- x86 PCI: call dmi_check_pciprobe()
- b43: Fix some TX/RX locking issues
- kprobes/arm: fix decoding of arithmetic immediate instructions
- kprobes/arm: fix cache flush address for instruction stub
- b43: Fix dual-PHY devices
- POWERPC: mpc5200: Fix unterminated of_device_id table
- reiserfs: Unpack tails on quota files
- sched: fix hrtick_start_fair and CPU-Hotplug
- vfs: fix permission checking in sys_utimensat
- md: fix use after free when removing rdev via sysfs
- mm: fix usemap initialization
- 2.6.25 regression: powertop says 120K wakeups/sec
.
[ maximilian attems ]
* Redisable old dup prism54 driver.
* Reenable accidentaly disabled SIS190. (closes: #478773)
* Add lmkl patch to unbreak HZ userspace aka perl5.10 build fix.
(closes: #480130)
.
[ Martin Michlmayr ]
* [armel] Disable some SCSI drives (that are disabled on arm) so the
ramdisk will fit in flash on NSLU2 (closes: #480310).
---
--
maks
--- End Message ---
Reply to: