Bug#420602: kernel fails to boot on SunBlade 100
Hi ema,
OK. Can you log in via ssh booting without atyfb:off?
I'll try that again tonight.
In the meantime, I guess not because neither with fbcon=map:1 nor without I
cannot hear the system's hard drive working (and this one does make noise).
So my conclusion is the system hangs before booting.
It would be interesting to take a look to what you have in /proc/fb and
the output of dmesg.
Here is the kernel log of the successful boot with video=atyfb:off:
klogd 1.4.1#18, log source = /proc/kmsg started.
PROMLIB: Sun IEEE Boot Prom 'OBP 4.0.45 2001/02/08 14:33'
PROMLIB: Root node compatible:
Linux version 2.6.18-4-sparc64 (Debian 2.6.18.dfsg.1-12) (waldi@debian.org)
(gcc version 4.1.2 20061115 (prerelease) (Debian 4.1.1-21)) #1 Mon Mar 26
11:16:07 UTC 2007
ARCH: SUN4U
Ethernet address: 00:03:ba:08:44:e8
PROM: Built device tree with 57152 bytes of memory.
On node 0 totalpages: 31512
DMA zone: 31512 pages, LIFO batch:7
CPU[0]: Caches D[sz(16384):line_sz(32)] I[sz(16384):line_sz(32)]
E[sz(262144):line_sz(64)]
Built 1 zonelists. Total pages: 31512
Kernel command line: root=/dev/hda1 ro video=atyfb:off
PID hash table entries: 1024 (order: 10, 8192 bytes)
Console: colour dummy device 80x25
Dentry cache hash table entries: 32768 (order: 5, 262144 bytes)
Inode-cache hash table entries: 16384 (order: 4, 131072 bytes)
Memory: 249496k available (2208k kernel code, 792k data, 136k init)
[fffff80000000000,000000000ff24000]
Calibrating delay using timer specific routine.. 11.12 BogoMIPS (lpj=22243)
Security Framework v1.0.0 initialized
SELinux: Disabled at boot.
Capability LSM initialized
Mount-cache hash table entries: 512
checking if image is initramfs... it is
Freeing initrd memory: 4495k freed
NET: Registered protocol family 16
PCI: Probing for controllers.
/pci@1f,0: SABRE PCI Bus Module
PCI quirk: region 0800-083f claimed by ali7101 ACPI
PCI quirk: region 0600-061f claimed by ali7101 SMB
PCI0(PBMA): Bus running at 33MHz
isa0: [dma -> (floppy) (parallel)] [power] [serial] [serial]
ebus0: [flashprom] [eeprom] [idprom]
power: Control reg at 1fe02000800 ... powerd running.
usbcore: registered new driver usbfs
usbcore: registered new driver hub
/pci@1f,0/ebus@c/eeprom@1,0: Clock regs at 000001fff1000000
NET: Registered protocol family 2
IP route cache hash table entries: 2048 (order: 1, 16384 bytes)
TCP established hash table entries: 8192 (order: 3, 65536 bytes)
TCP bind hash table entries: 4096 (order: 2, 32768 bytes)
TCP: Hash tables configured (established 8192 bind 4096)
TCP reno registered
audit: initializing netlink socket (disabled)
audit(1177443604.232:1): initialized
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 8192 bytes)
Initializing Cryptographic API
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered (default)
Activating ISA DMA hang workarounds.
Console: switching to mono PROM 80x34
rtc_init: no PC rtc found
[drm] Initialized drm 1.0.1 20051102
f007263c: ttyS0 at MMIO 0x1fe020003f8 (irq = 9) is a 16550A
f0073d88: ttyS1 at MMIO 0x1fe020002e8 (irq = 9) is a 16550A
RAMDISK driver initialized: 16 RAM disks of 16384K size 1024 blocksize
loop: loaded (max 8 devices)
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
rtc_sun_init: Registered Mostek RTC driver.
usbcore: registered new driver usbhid
drivers/usb/input/hid-core.c: v2.6:USB HID core driver
mice: PS/2 mouse device common for all mice
TCP bic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
sungem.c:v0.98 8/24/03 David S. Miller (davem@redhat.com)
PHY ID: 437421, addr: 1
eth0: Sun GEM (PCI) 10/100/1000BaseT Ethernet 00:03:ba:08:44:e8
eth0: Found Generic MII PHY
ieee1394: Initialized config rom entry `ip1394'
ohci_hcd: 2005 April 22 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI)
ohci_hcd 0000:00:0c.3: OHCI Host Controller
ohci_hcd 0000:00:0c.3: new USB bus registered, assigned bus number 1
ohci_hcd 0000:00:0c.3: irq 12, io mem 0x1ff02000000
Linux Tulip driver version 1.1.13-NAPI (May 11, 2002)
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 4 ports detected
ALI15X3: IDE controller at PCI slot 0000:00:0d.0
ALI15X3: chipset revision 195
ALI15X3: 100%% native mode on irq 15
ide0: BM-DMA at 0x1fe02000a20-0x1fe02000a27, BIOS settings: hda:pio,
hdb:pio
ide1: BM-DMA at 0x1fe02000a28-0x1fe02000a2f, BIOS settings: hdc:pio,
hdd:pio
eth0: Link is up at 100 Mbps, full-duplex.
Probing IDE interface ide0...
usb 1-2: new low speed USB device using ohci_hcd and address 2
hda: ST315320A, ATA DISK drive
usb 1-2: configuration #1 chosen from 1 choice
input: HID 0430:0005 as /class/input/input0
input: USB HID v1.00 Keyboard [HID 0430:0005] on usb-0000:00:0c.3-2
hdb: LTN485S, ATAPI CD/DVD-ROM drive
ide0 at 0x1fe02000a00-0x1fe02000a07,0x1fe02000a1a on irq 15
Probing IDE interface ide1...
hdc: ST3120026A, ATA DISK drive
ide1 at 0x1fe02000a10-0x1fe02000a17,0x1fe02000a0a on irq 15
tulip0: no phy info, aborting mtable build
eth1: Macronix 98715 PMAC rev 37 at 000001fe02001000, 00:80:C6:EF:46:13, IRQ
17.
tulip1: MII transceiver #1 config 3100 status 7809 advertising 01e1.
eth2: Lite-On 82c168 PNIC rev 32 at 000001fe02001100, 00:C0:F0:5C:CA:67, IRQ
18.
hda: max request size: 128KiB
hda: 29888820 sectors (15303 MB) w/2048KiB Cache, CHS=29651/16/63, UDMA(66)
hda: cache flushes not supported
hda:<6>ohci1394: fw-host0: OHCI-1394 1.0 (PCI): IRQ=[11]
MMIO=[1ff00420000-1ff004207ff] Max Packet=[2048] IR/IT contexts=[4/4]
hda1 hda2 hda3
hdc: max request size: 128KiB
hdc: 234441648 sectors (120034 MB) w/8192KiB Cache, CHS=16383/255/63,
UDMA(66)
hdc: cache flushes supported
hdc:<6>hdb: ATAPI 48X CD-ROM drive, 120kB Cache
Uniform CD-ROM driver Revision: 3.20
hdc1 hdc3
ieee1394: Host added: ID:BUS[0-00:1023] GUID[0003bafffe0844e8]
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
eth1394: eth3: IEEE-1394 IPv4 over 1394 Ethernet (fw-host0)
Adding 490880k swap on /dev/hda2. Priority:-1 extents:1 across:490880k
EXT3 FS on hda1, internal journal
device-mapper: ioctl: 4.7.0-ioctl (2006-06-24) initialised:
dm-devel@redhat.com
ReiserFS: hdc1: found reiserfs format "3.6" with standard journal
ReiserFS: hdc1: using ordered data mode
ReiserFS: hdc1: journal params: device hdc1, size 8192, journal first block
18, max trans len 1024, max batch 900, max commit age 30, max trans age 30
ReiserFS: hdc1: checking transaction log (hdc1)
ReiserFS: hdc1: Using r5 hash to sort names
eth0: Link is up at 100 Mbps, full-duplex.
eth0: Pause is disabled
NET: Registered protocol family 10
lo: Disabled Privacy Extensions
IPv6 over IPv4 tunneling driver
ip_tables: (C) 2000-2006 Netfilter Core Team
Netfilter messages via NETLINK v0.30.
ip_conntrack version 2.4 (993 buckets, 7944 max) - 304 bytes per conntrack
Bridge firewalling registered
ip_conntrack_pptp version 3.1 loaded
ip_nat_pptp version 3.0 loaded
ClusterIP Version 0.8 loaded successfully
ip_tables: conntrack match: invalid size 80 != 72
ip_tables: connmark match: invalid size 24 != 16
ip_tables: MARK target: invalid size 16 != 8
ip_tables: CONNMARK target: invalid size 24 != 16
eth0: no IPv6 routers present
eth1: no IPv6 routers present
eth2: no IPv6 routers present
Installing knfsd (copyright (C) 1996 okir@monad.swb.de).
NFSD: Using /var/lib/nfs/v4recovery as the NFSv4 state recovery directory
NFSD: starting 90-second grace period
/proc/fb looks empty:
$ ls -l /proc/fb
-r--r--r-- 1 root root 0 2007-04-25 14:29 /proc/fb
$ cat /proc/fb
$
Do you need other information?
Regards,
Etienne
_________________________________________________________________
Don't just search. Find. Check out the new MSN Search!
http://search.msn.com/
Reply to: