[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Bug#355672: marked as done (Boot hangs on SATA harddrive)

Your message dated Fri, 31 Mar 2006 09:09:44 -0700
with message-id <20060331160943.GB22475@colo>
and subject line [tibor.radvanyi@gmail.com: Bug#355672: Boot hangs, but for different reasons]
has caused the attached Bug report to be marked as done.

This means that you claim that the problem has been dealt with.
If this is not the case it is now your responsibility to reopen the
Bug report if necessary, and/or fix the problem forthwith.

(NB: If you are a system administrator and have no idea what I am
talking about this indicates a serious mail system misconfiguration
somewhere.  Please contact me immediately.)

Debian bug tracking system administrator
(administrator, Debian Bugs database)
--- Begin Message --- 
Package: linux-image-2.6.15-1-686-smp
Version: 2.6.15-7

I'm using Debian testing on a Dell Optiplex GX280 desktop machine with
standard Debian kernel package of linux-image-2.6.12-1-686-smp. This
computer has a SATA hard drive which is handled by the kernel
perfectly.

I've installed linux-image-2.6.15-1-686-smp. The installation went
fine installing all the dependencies as well.
The boot process with this kernel is running smoothly up to the point
when after loading modules from the initial ramdisk the hard drive
should be accessed. This is a point when the process hangs. I suspect
the problem is related to loading the SATA modules.

The problem has been recognized by others as well, but I could not
find it in the list of reported bugs:
http://lists.debian.org/debian-kernel/2006/01/msg00716.html

The SATA relevant part of lspci -vvv:
0000:00:1f.2 IDE interface: Intel Corp. 82801FB/FW (ICH6/ICH6W) SATA
Controller (rev 03) (prog-if 8f [Master SecP SecO PriP PriO])
        Subsystem: Dell: Unknown device 0179
        Control: I/O+ Mem- BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
        Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium
>TAbort- <TAbort- <MAbort- >SERR- <PERR-
        Latency: 0
        Interrupt: pin C routed to IRQ 217
        Region 0: I/O ports at fe00 [size=8]
        Region 1: I/O ports at fe10 [size=4]
        Region 2: I/O ports at fe20 [size=8]
        Region 3: I/O ports at fe30 [size=4]
        Region 4: I/O ports at fea0 [size=16]
        Capabilities: [70] Power Management version 2
                Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot+,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-


Regards,
Tibor Radvanyi

--- End Message ---
--- Begin Message --- 
Closing then, thanks.

-- 
dann frazier

--- End Message ---
Reply to: