Bug#342931: doesn't work on alpha
On Sun, Dec 11, 2005 at 07:36:58PM +0100, Norbert Tretkowski wrote:
<snipp>
> Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
> kjournald starting. Commit interval 5 seconds
> EXT3-fs: mounted filesystem with ordered data mode.
> Kernel panic - not syncing: Attempted to kill init!
>
> The qla1280 module is the right one for my rootfilesystem, the ext3
> module is also loaded.
hmm so fstype from klibc seems to work it recognises your ext3 root fs.
> Using break=mount:
>
> SCSI subsystem initialized
> qla1280: QLA1040 found on PCI bus 1, dev 8
> scsi(0:0): Resetting SCSI BUS
> scsi0 : QLogic QLA1040 PCI to SCSI Host Adapter
> Firmware version: 7.65.06, Driver version 3.25
> Vendor: MICROP Model: 3391WS Rev: X502
> Type: Direct-Access ANSI SCSI revision: 02
> scsi(0:0:0:0): Sync: period 10, offset 12, Wide
> SCSI device sda: 17780058 512-byte hdwr sectors (9103 MB)
> SCSI device sda: drive cache: write back
> SCSI device sda: 17780058 512-byte hdwr sectors (9103 MB)
> SCSI device sda: drive cache: write back
> sda: sda1 sda2 sda3 sda4
> Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
> <system hangs>
that is an busybox bug, is latest busybox known to work on alpha?
should drop you into a shell.
> Using break=init:
>
> SCSI subsystem initialized
> qla1280: QLA1040 found on PCI bus 1, dev 8
> scsi(0:0): Resetting SCSI BUS
> scsi0 : QLogic QLA1040 PCI to SCSI Host Adapter
> Firmware version: 7.65.06, Driver version 3.25
> Vendor: MICROP Model: 3391WS Rev: X502
> Type: Direct-Access ANSI SCSI revision: 02
> scsi(0:0:0:0): Sync: period 10, offset 12, Wide
> SCSI device sda: 17780058 512-byte hdwr sectors (9103 MB)
> SCSI device sda: drive cache: write back
> SCSI device sda: 17780058 512-byte hdwr sectors (9103 MB)
> SCSI device sda: drive cache: write back
> sda: sda1 sda2 sda3 sda4
> Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
> kjournald starting. Commit interval 5 seconds
> EXT3-fs: mounted filesystem with ordered data mode.
> <system hangs>
ok, so the initramfs-tools bug seems to be run-init of klibc:
a bit hard to debug if it's not possible to get into the bb shell.
will think about it and reping.
thanks for your testing
--
maks
Reply to: