Bug#267079: kernel-image-2.6.7-1-686: T41p can't sleep with ACPI
On Fri, 20 Aug 2004, jlquinn wrote:
> Attempting to put an IBM T41p to sleep does not work. The following
> chunk of kernel log shows why:
>
> Aug 20 03:10:09 localhost kernel: e1000: eth0: e1000_watchdog: NIC Link
> is Up 100 Mbps Full D
> uplex
> Aug 20 03:10:12 localhost kernel: PM: Preparing system for suspend
> Aug 20 03:10:17 localhost kernel: Stopping tasks:
> ===========================================
> =============================|
> Aug 20 03:10:17 localhost kernel: PCI: Setting latency timer of device
> 0000:00:1d.7 to 64
> Aug 20 03:10:17 localhost kernel: Could not suspend device 0000:00:1d.7:
> error -5
> Aug 20 03:10:17 localhost kernel: PCI: Enabling device 0000:00:1f.5
> (0000 -> 0003)
> Aug 20 03:10:17 localhost kernel: i810_audio: Primary codec has ID 0
> Aug 20 03:10:17 localhost kernel: ac97_codec: AC97 Audio codec, id:
> ADS116 (Unknown)
> Aug 20 03:10:17 localhost kernel: PCI: Setting latency timer of device
> 0000:00:1f.6 to 64
> Aug 20 03:10:17 localhost kernel: Restarting tasks... done
> Aug 20 03:10:17 localhost kernel: apm: BIOS version 1.2 Flags 0x03
> (Driver version 1.16ac)
> Aug 20 03:10:17 localhost kernel: apm: overridden by ACPI.
> Aug 20 03:10:19 localhost kernel: e1000: eth0: e1000_watchdog: NIC Link is Up 100 Mbps Full Duplex
>
> Device 1d.7 according to lspci -vvv is as follows:
>
> 0000:00:1d.7 USB Controller: Intel Corp. 82801DB/DBM (ICH4/ICH4-M) USB
> 2.0 EHCI Controller (rev 01) (prog-if20 [EHCI])
> Subsystem: IBM: Unknown device 052e
> Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B-
> Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
> Latency: 0
> Interrupt: pin D routed to IRQ 11
> Region 0: Memory at c0000000 (32-bit, non-prefetchable) [size=1K]
> Capabilities: [50] Power Management version 2
> Flags: PMEClk- DSI- D1- D2- AuxCurrent=375mA PME(D0+,D1-,D2-,D3hot+,D3cold+)
> Status: D0 PME-Enable- DSel=0
> DScale=0 PME-
> Capabilities: [58] #0a [2080]
>
>
does the latest kernel-image 2.6.10 from unstable work for your t41?
thanks for your feedback.
--
maks
Reply to: