Bug#272693: (no subject)
To whom it may concern;
I have a similar bug to this one, at least I think it is. During boot,
using the 2.6.8 kernel, the boot process will hang at the point where
hotplug is loading the usb modules.
The computer recognizes both my scanner and printer, but then when
hotplug goes to load the modules I get the following error: control
timeout on ep0in. It hangs at that point and I have to hit the reset
buttton or power button, uplug the usb devices and then it will boot
successfully.
If I unplug the USB devices during boot, and then do a
"/etc/init.d/hotplug restart" from the command line hotplug is able to
load the correct modules without hanging. Even this will fail though
if I boot into another kernel (2.4.26) and then go back to the 2.6.8
kernel. Once I do that hotplug will always hang at loading usb modules.
I am running an AMD Athlon (800mhz) on a Gigabyte GA-7IXE4
motherboard. I have sarge installed.
Reply to: