Bug#256374: Installation hangs on Compaq Presario 1220 while loading module 'ide-cd' during hardware detection for the CD-ROM drive (beta4, i386, linux26)

[Robin Blondon <robinb@hfx.eastlink.ca>]

Per Olofsson wrote:

> On Sat, Jul 03, 2004 at 08:58 -0300, Robin Blondon wrote:
>  
>
> > Under 2.6, when I have i82365 and orinoco_cs in /etc/modules, 
> > yenta_socket is not loaded and it doesn't look like it tries to load it 
> > (I checked boot messages, dmesg, and syslog) but it does attempt to load 
> > memory_cs. When I do not have i82365 and orinoco_cs in /etc/modules, it 
> > does load it.
> >    
>
> But can you check with lsmod after pcmcia has started? And what does
> "cardctl ident" say?
>
>  
Under 2.6, when I have i82365 and orinoco_cs in /etc/modules, lsmod 
shows that yenta_socket is not loaded. "cardctl ident" says:
Socket 0:
cs: unable to map card memory!
cs: unable to map card memory!
no product info available
cs: unable to map card memory!
cs: unable to map card memory!
cs: unable to map card memory!
cs: unable to map card memory!
When I kill cardmgr and run "cardctl ident" again, it gives the same 
results.


When I do not have i82365 and orinoco_cs in /etc/modules, lsmod shows 
that yenta_socket is loaded. "cardctl ident" says:
open_sock(): No such device
Also, if I try to run cardmgr, cardmgr says:
cardmgr[1118]: no sockets found!

- Robin