AVerMedia EZ Capture (bt 878)
Carissimi,
mi trovo tra le mani (cioè in uno slot PCI) la scheda in oggetto.
Si tratta di una scheda di acquisizione video (non una scheda TV - non c'è
sintonizzatore).
E mi trovo in difficoltà.
Prima di entrare nei dettagli, qualcuno ce l'ha e riesce a farla funzionare?
Se si, datemi un po' di conforto.
Grazie in ogni caso,
augh
~~~~~~~~~~~
Ecco i dettagli:
Vi dico cosa ho fatto finora:
#lspci
0000:00:09.0 Multimedia video controller: Brooktree Corporation Bt878
Video Capture (rev 11)
0000:00:09.1 Multimedia controller: Brooktree Corporation Bt878 Audio
Capture (rev 11)
Soppungo che il supporto sia bttv, lo abilito nel kernel (2.6.14) e procedo:
bttv: driver version 0.9.16 loaded
bttv: using 8 buffers with 2080k (520 pages) each for capture
bttv: Bt8xx card found (0).
bttv0: Bt878 (rev 17) at 0000:00:09.0, irq: 5, latency: 32, mmio: 0xea003000
bttv0: using: *** UNKNOWN/GENERIC *** [card=0,autodetected]
bttv0: gpio: en=00000000, out=00000000 in=00ffffff [init]
bttv0: using tuner=-1
bttv0: i2c: checking for MSP34xx @ 0x80... not found
bttv0: i2c: checking for TDA9875 @ 0xb0... not found
bttv0: i2c: checking for TDA7432 @ 0x8a... not found
bttv0: i2c: checking for TDA9887 @ 0x86... <6>Adding 499960k swap on
/dev/hda2. Priority:-1 extents:1 across:499960k
bttv0: registered device video0
bttv0: registered device vbi0
Primo problema:
la scehda non è riconosciuta (*** UNKNOWN/GENERIC ***) ma nel BTTV HOWTO,
pur essendoci il riferimento alla EZ Capture, non dice che numero devo passare
al caricamento del modulo.
Secondo problema:
ollego l'uscita di una telecamera all'uscita, provo ad aprire xawtv
(dovrebbe vedere
quello che passa in /dev/video0, no?): schermo BLU!
Reply to: