Re: Nuova gestione scanner....a voi va?
On Sat, 2004-05-01 at 17:40, Francesco wrote:
> Accidenti, continuo a non approvare questo cambio di gestione degli
> scanner tramite hotplug libusb ecc visto che non mi va piu' nulla!
>
> Veniamo al problema:
>
> found USB scanner (vendor=0x04b8 [EPSON], product=0x010b
> [Perfection1240]) at libusb:001:003
> # Your USB scanner was (probably) detected. It may or may not be
> supported by
> # SANE. Try scanimage -L and read the backend's manpage.
>
>
>
> E lo scanner c'e', poi
>
>
>
> jabawack:/home/frank# cat /etc/hotplug/usb/libsane.usermap
> # This file is installed by the libsane Debian package.
> #
> # Sample entry (replace 0xVVVV and 0xPPPP with vendor ID and product ID
> respectively) :
> libusbscanner 0x0003 0x04b8 0x010b 0x0000
> 0x0000 0x00 0x00 0x00
> 0x00 0x00 0x00 0x00000000
> #
>
>
>
> I parametri tornano,
>
>
>
>
> jabawack:/home/frank# cat /etc/fstab
>
> <cut>
> none /proc/bus/usb usbfs defaults 0 0
>
> usbfs montato,
>
>
>
> jabawack:/home/frank# ll /proc/bus/usb/001/003
> -rw-r--r-- 1 root root 50 May 1 17:31
> /proc/bus/usb/001/003
>
>
>
> li avevo messi a 660 come root.scanner ma dopo un riavvio sono tornati
> come prima ....bah
>
> jabawack:/home/frank# cat /etc/sane.d/epson.conf
>
> # USB scanner - only enable this if you have an EPSON scanner. It could
> # otherwise block your non-EPSON scanner from being
> # recognized.
> # Depending on your distribution, you may need either the
> # first or the second entry.
>
> #/dev/usb/scanner0
> /proc/bus/usb/001/003
>
>
> Hotplug e' montato ma da questo messaggio:
>
> jabawack:/etc/init.d# ./hotplug restart
> Restarting hotplug subsystem: input
> net
> pci
> usb
> input
> evdev: already loaded
> evdev: already loaded
> net
> pci
> uhci-hcd: loaded sucessfully
> uhci-hcd: already loaded
> ignore pci display device on 01:00.0
> snd-emu10k1: already loaded
> via-rhine: already loaded
> usb
> ** can't synthesize root hub events
>
> e a me lo scanner non va neanche a spingere....
>
> A qualcuno lo scanner va settato alla nuova maniera?
>
Ho risolto con questa linea in /etc/sane.d/epson.conf
usb libusb:001:003
Haloa!
--
Francesco
(o< (o_
//\ //\
V_/_....Powered By Debian GNU/Linux....V_/_
http://xoomer.virgilio.it/frpiano
Reply to: