Re: eth0 problems..

["Doug Griswold" <griswld@cio.sc.gov>]

Try checking with ethtool.  Which nic are you using?

>>> Simon Buchanan <nmc@orcon.net.nz> 09/27/04 8:13 PM >>>
Hi There, i have a debian woody box that i am connected to via ssh, here

is the ifconfig:

eth0      Link encap:Ethernet  HWaddr 00:50:FC:XX:XX:XX
           inet addr:203.109.xxx.xx  Bcast:203.109.xxx.xx 
Mask:255.255.255.xxx
           UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
           RX packets:4109 errors:0 dropped:0 overruns:0 frame:0
           TX packets:1079 errors:8 dropped:0 overruns:0 carrier:16
           collisions:23 txqueuelen:100
           RX bytes:809755 (790.7 KiB)  TX bytes:169903 (165.9 KiB)
           Interrupt:16 Base address:0xa000

When i check the link with mii-tool i get the following response:

box:/etc# mii-tool -v eth0
eth0: 10 Mbit, half duplex, no link
   product info: vendor 00:00:00, model 0 rev 0
   basic mode:   10 Mbit, half duplex
   basic status: no link
   capabilities:
   advertising:

NO LINK? But im connected to the thing - and its connected to a 100Mbit 
hub... Is this a problem with the ethernet card?

Thanks

Simon


-- 
To UNSUBSCRIBE, email to debian-isp-REQUEST@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact
listmaster@lists.debian.org