I installed debian woody on the server. On booting only one ethernet is active. The second one is not being detected. Both ethernets are onboard. eepro100 is the driver used. Following shows the details:
02:08.0 Ethernet controller: Intel Corp. 82557 [Ethernet Pro 100] (rev 10)
Subsystem: Intel Corp.: Unknown device 1040
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 66 (2000ns min, 14000ns max), cache line size 10
Interrupt: pin A routed to IRQ 18
Region 0: Memory at f4122000 (32-bit, non-prefetchable) [size=4K]
Region 1: I/O ports at 2400 [size=64]
Region 2: Memory at f4100000 (32-bit, non-prefetchable)
[size=128K]
Capabilities: [dc] Power Management version 2
Flags: PMEClk- DSI+ D1+ D2+ AuxCurrent=0mA PME(D0+,D1+,D2+,D3hot+,D3cold+)
Status: D0 PME-Enable- DSel=0 DScale=2 PME-
00:0b.0 Ethernet controller: Intel Corp.: Unknown device 100f (rev 01)
Subsystem: Intel Corp.: Unknown device 1001
Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV+ VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap+ 66Mhz+ UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (63750ns min), cache line size 10
Interrupt: pin A routed to IRQ 19
Region 0: Memory at f4000000 (32-bit, non-prefetchable) [size=128K]
Region 2: I/O ports at 1000 [size=64]
Capabilities: [dc] Power Management version
2
Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA PME(D0+,D1-,D2-,D3hot+,D3cold-)
Status: D0 PME-Enable- DSel=0 DScale=1 PME-
Capabilities: [e4] #07 [0002]
Capabilities: [f0] Message Signalled Interrupts: 64bit+ Queue=0/0 Enable-
Address: 0000000000000000 Data: 0000
Can anyone please provide me some hints on making the second ethernet active.