Hi, I’m having some problems routing
ipv6 on my debian box. I’ve got a tunnel setup, and radvd running, which
is fine, my client gets an ip address, but when I try to ping6 something from
my client (outside of my network) I get a Request timed out, where as if I do
the same ping6 on my linux box I get a response. This is my lan interface: eth2 Link
encap:Ethernet HWaddr
00:05:1C:0B:DC:6B
inet addr:192.168.0.254
Bcast:192.168.0.255
Mask:255.255.255.0
inet6 addr: fe80::205:1cff:fe0b:dc6b/10 Scope:Link inet6 addr:
2001:c78:2003:e008::2/62 Scope:Global
UP BROADCAST RUNNING MULTICAST
MTU:1500 Metric:1
RX packets:74450616 errors:13 dropped:35 overruns:13 frame:0
TX packets:68820758 errors:0 dropped:0 overruns:32 carrier:0
collisions:1391688 txqueuelen:100
RX bytes:364917421 (348.0 MiB)
TX bytes:1571854906 (1.4 GiB)
Interrupt:5 Base address:0x7000 This is my routing table ns1:~# ip -6 route show 2001:c78:2003:e008::/127 via :: dev
ipv6 proto kernel metric 256 mtu 1480 advmss 1420 2001:c78:2003:e008::/62 dev
eth2 proto kernel metric 256 mtu 1500 advmss 1440 fe80::/10 dev eth0 proto kernel metric 256 mtu 1500 advmss 1440 fe80::/10 dev eth1 proto kernel metric 256 mtu 1500 advmss 1440 fe80::/10 dev eth2 proto kernel metric 256 mtu 1500 advmss 1440 fe80::/10 via :: dev ipv6 proto kernel metric 256 mtu 1480 advmss 1420 ff00::/8 dev eth0 proto kernel metric 256 mtu 1500 advmss 1440 ff00::/8 dev eth1 proto kernel metric 256 mtu 1500 advmss 1440 ff00::/8 dev eth2 proto kernel metric 256 mtu 1500 advmss 1440 ff00::/8 dev ipv6 proto kernel metric 256 mtu 1480 advmss 1420 default dev ipv6 metric 1024 mtu 1480 advmss 1420 unreachable default dev lo metric -1 error -101 My clients ip is
2001:c78:2003:8:3d44:f577:c06b:ad19 Thanks for your help Nick |