Hi, I’m having some problems
routing ipv6 on my debian box. I’ve got a
tunnel setup, and radvd running, which is fine, my
client gets an ip address, but when I try to ping6
something from my client (outside of my network) I get a Request timed out,
where as if I do the same ping6 on my linux box I get
a response. This is my lan interface: eth2 Link encap:Ethernet HWaddr
00:05:1C:0B:DC:6B inet
addr:192.168.0.254
Bcast:192.168.0.255
Mask:255.255.255.0 inet6 addr: fe80::205:1cff:fe0b:dc6b/10 Scope:Link inet6 addr: 2001:c78:2003:e008::2/62 Scope:Global UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:74450616
errors:13 dropped:35 overruns:13 frame:0
TX packets:68820758 errors:0 dropped:0 overruns:32 carrier:0 collisions:1391688
txqueuelen:100 RX bytes:364917421
(348.0 MiB) TX
bytes:1571854906 (1.4 GiB) Interrupt:5
Base address:0x7000 This is my routing table ns1:~# ip
-6 route show 2001:c78:2003:e008::/127 via :: dev ipv6
proto kernel metric 256 mtu 1480 advmss 1420 2001:c78:2003:e008::/62 dev eth2 proto
kernel metric 256 mtu 1500 advmss 1440 fe80::/10
dev eth0 proto kernel metric 256
mtu 1500 advmss 1440 fe80::/10
dev eth1 proto kernel metric 256
mtu 1500 advmss 1440 fe80::/10
dev eth2 proto kernel metric 256
mtu 1500 advmss 1440 fe80::/10
via :: dev ipv6 proto kernel metric 256
mtu 1480 advmss 1420 ff00::/8
dev eth0 proto kernel metric 256
mtu 1500 advmss 1440 ff00::/8
dev eth1 proto kernel metric 256
mtu 1500 advmss 1440 ff00::/8
dev eth2 proto kernel metric 256
mtu 1500 advmss 1440 ff00::/8
dev ipv6 proto kernel metric 256
mtu 1480 advmss 1420 default dev ipv6 metric 1024 mtu 1480 advmss 1420 unreachable default dev lo metric -1 error -101 My clients ip is 2001:c78:2003:8:3d44:f577:c06b:ad19 Thanks for your help Nick |