RE: Linux on A180C
Carlos,
Below is the information I was able to get from the terminal.
------------------------------------------------------------------------
-------
Information: No console specified on kernel command line. This is
normal.
PALO will choose the console currently used by firmware (serial).
Current command line:
0/vmlinux root=/dev/ram initrd=0/ramdisk console=ttyS0 TERM=vt102
0: 0/vmlinux
1: root=/dev/ram
2: initrd=0/ramdisk
3: console=ttyS0
4: TERM=vt102
Edit which field?
(or 'b' to boot with this command line)? 0
0/vmlinux32
Current command line:
0/vmlinux32 root=/dev/ram initrd=0/ramdisk console=ttyS0 TERM=vt102
0: 0/vmlinux32
1: root=/dev/ram
2: initrd=0/ramdisk
3: console=ttyS0
4: TERM=vt102
Edit which field?
(or 'b' to boot with this command line)? b
Command line for kernel: 'root=/dev/ram console=ttyS0 TERM=vt102'
Selected kernel: /vmlinux32 from partition 0
Selected ramdisk: /ramdisk from partition 0
ELF32 executable
Entry 00100000 first 00100000 n 6
Segment 0 load 00100000 size 1618208 mediaptr 0x1000
Segment 1 load 0028c000 size 287728 mediaptr 0x18d000
Segment 2 load 002d4000 size 379072 mediaptr 0x1d4000
Segment 3 load 00334000 size 8192 mediaptr 0x231000
Segment 4 load 00338000 size 32768 mediaptr 0x233000
Segment 5 load 003750e8 size 83184 mediaptr 0x23b0e8
Loading ramdisk 1946807 bytes @ 3fe14000...
Branching to kernel entry point 0x00100000. If this is the last
message you see, you may need to switch your console. This is
a common symptom -- search the FAQ and mailing list at parisc-linux.org
FLT CBFB
------------------------------------------------------------------------
----
Thanks
-----Original Message-----
From: Carlos O'Donell [mailto:carlos@baldric.uwo.ca]
Sent: Tuesday, August 13, 2002 7:27 AM
To: Pad Hosmane
Cc: debian-hppa@lists.debian.org
Subject: Re: Linux on A180C
> Hi,
> I am trying to load Debian Linux on A180C. When I boot using the
> following command "boot p1 ipl". Then I select vmlinux32 kernel to
boot
> from install CD, it boots and then stops on error
> giving the error message FLT CBFB. This happens right after loading
> ramdisk. Anybody was successful in loading linix on HP9000/A180c???
>
> Thanks
>
Could you post the entire bootup log?
c.
--
To UNSUBSCRIBE, email to debian-hppa-request@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact
listmaster@lists.debian.org
Reply to: