move from 0.9.3 to woody
Hi there,
I've installed woddy over an old 0.9.3 Linux installation and now it's
working pretty fine. The developers did a very good work !
There are just two errors which came up during the installation. There are
some errors with libgnome dependencies (sorry I can't remember the exact
message). But the system works very well with KDE.
regards,
Frank
FYI the system information:
palo version 1.0 bame@palinux Mon Apr 1 10:03:01 MST 2002
ELF32 executable
Partition Start(MB) End(MB) Id Type
1 1 121 82 swap
2 122 131 f0 Palo
3 132 2046 83 ext2
ipl: addr 127610880 size 30720 entry 0x0
ko 0x0 ksz 0 k64o 0x0 k64sz 0 rdo 0 rdsz 0
<3/boot/vmlinux root=/dev/sda3 HOME=/>
ipl: addr 127610880 size 30720 entry 0x0
ko 0x79f3000 ksz 3687647 k64o 0x0 k64sz 0 rdo 0 rdsz 0
<3/boot/vmlinux root=/dev/sda3 HOME=/>
Linux version 2.4.17-32 (root@paer) (gcc version 3.0.4) #1 Sat Mar 16 17:09:00 MST 2002
FP[0] enabled: Rev 1 Model 15
The 32-bit Kernel has started...
Determining PDC firmware type: System Map.
model 00005060 00000481 00000000 02020202 77a6e0d7 100000f0 00000004 000000ba 000000ba
vers 00000008
CPUID vers 15 rev 8 (0x000001e8)
model 9000/779/C160L
Total Memory: 128 Mb
pagetable_init
On node 0 totalpages: 32768
zone(0): 32768 pages.
zone(1): 0 pages.
zone(2): 0 pages.
LED display at f0190001 registered
Kernel command line: root=/dev/sda3 HOME=/ console=tty0 sti=8/24 sti_font=VGA8x16 TERM=linux palo_kernel=3/boot/vmlinux
Console: colour dummy device 160x64
Calibrating delay loop... 106.49 BogoMIPS
Memory: 125976k available
Dentry-cache hash table entries: 16384 (order: 5, 131072 bytes)
Inode-cache hash table entries: 8192 (order: 4, 65536 bytes)
Mount-cache hash table entries: 2048 (order: 2, 16384 bytes)
Buffer-cache hash table entries: 4096 (order: 2, 16384 bytes)
Page-cache hash table entries: 32768 (order: 5, 131072 bytes)
Searching for devices...
Found devices:
1. Merlin+ 132 Dino PS/2 Port (10) at 0xfff81000 [1], versions 0x22, 0x0, 0x96
2. Merlin+ 132 Dino RS-232 (10) at 0xfff83000 [3], versions 0x22, 0x0, 0x8c
3. Phantom PseudoBC GSC+ Port (7) at 0xffc00000 [8], versions 0x504, 0x0, 0x0
4. Dino PCI Bridge (13) at 0xfff80000 [8/0], versions 0x680, 0x3, 0xa
5. Raven U/L2 Core FW-SCSI (4) at 0xfff8c000 [8/12], versions 0x3b, 0x0, 0x89
6. Raven U/L2 Core BA (11) at 0xffd00000 [8/16], versions 0x3b, 0x0, 0x81, additional addresses: 0xffd0c000 0xffc00000
7. Raven U/L2 Core Centronics (10) at 0xffd02000 [8/16/0], versions 0x3b, 0x0, 0x74, additional addresses: 0xffd01000 0xffd03000
8. Raven U/L2 Core Audio (10) at 0xffd04000 [8/16/1], versions 0x3b, 0x4, 0x7b
9. Raven U/L2 Core RS-232 (10) at 0xffd05000 [8/16/4], versions 0x3b, 0x0, 0x8c
10. Raven U/L2 Core SCSI (10) at 0xffd06000 [8/16/5], versions 0x3b, 0x0, 0x82
11. Raven U/L2 Core LAN (802.3) (10) at 0xffd07000 [8/16/6], versions 0x3b, 0x0, 0x8a
12. Raven U/L2 Core PS/2 Port (10) at 0xffd08000 [8/16/7], versions 0x3b, 0x0, 0x84
13. Raven U/L2 Core PS/2 Port (10) at 0xffd08100 [8/16/8], versions 0x3b, 0x0, 0x84
14. Raven Backplane Wax BA (11) at 0xffe00000 [8/20], versions 0x17, 0x0, 0x8e
15. Raven Backplane Wax HIL (10) at 0xffe01000 [8/20/1], versions 0x17, 0x0, 0x73
16. Raven Backplane RS-232 (10) at 0xffe02000 [8/20/2], versions 0x17, 0x0, 0x8c
17. Raven Backplane Wax EISA BA (11) at 0xfc000000 [8/20/5], versions 0x17, 0x0, 0x90, additional addresses: 0xffc88000
18. Gecko GSC Core Graphics (10) at 0xf8000000 [8/24], versions 0x16, 0x0, 0x85, additional addresses: 0xf0011000
19. Raven L2 160 (9000/779/C160L) (0) at 0xfffbe000 [62], versions 0x508, 0x0, 0x4
20. Memory (1) at 0xfffbf000 [63], versions 0x6b, 0x0, 0x9
CPU(s): 1 x PA7300LC (PCX-L2) at 160.000000 MHz
Lasi version 0 at 0xffd00000 found.
Wax at 0xffe00000 found.
Wax: HIL Keyboard-NMI registered.
Wax EISA Adapter found at 0xfc000000
EISA EEPROM at 0xffc88000
Enumerating EISA bus
EISA slot 1 a configured board was not detected ( expected ___FFFF)
Dino version 3.1 found at 0xfff80000
Dino: No PCI devices enabled.
POSIX conformance testing by UNIFIX
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Enabled soft power switch (polling mode, io=0xf0140000).
Starting kswapd
Journalled Block Device driver loaded
parport_init_chip: initialize bidirectional-mode.
parport0: PC-style at 0xffd02800, irq 88 [PCSPP,TRISTATE]
STI word mode ROM at f0011000, hpa=f8000000
STI word mode ROM, id 2d08c0a7-9a02587, conforms to spec rev. 8.07
STI device: INTERNAL_EG_1280
Console: switching to colour frame buffer device 160x64
fb0: stifb 1280x1024-8 frame buffer device, id: 2d08c0a7, mmio: 0xf8100000
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled
ttyS00 at iomem 0xffd05800 (irq = 90) is a 16550A
Serial: device 0xfff83000 not configured.
Enable support for Wax, Lasi, Asp or Dino.
ttyS01 at iomem 0xffe02800 (irq = 121) is a 16550A
PS/2 keyboard port at 0xffd08000 (irq 69) found, device attached.
PS/2 psaux port at 0xffd08100 (irq 69) found, device attached.
Found HIL at 0xffe01000, IRQ 126
HIL: no keyboard present.
lp0: using parport0 (interrupt-driven).
Generic RTC Driver v1.02 05/27/1999 Sam Creasey (sammy@oh.verio.com)
block: 128 slots per queue, batch=32
RAMDISK driver initialized: 16 RAM disks of 6144K size 1024 blocksize
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
loop: loaded (max 8 devices)
Found i82596 at 0xffd07000, IRQ 87
eth0: 82596 at 0xffd07000, 00 60 B0 7D C4 17 IRQ 87.82596.c $Revision: 1.28 $
SCSI subsystem driver Revision: 1.00
zalon_scsi_callback: Zalon vers field is 0x1, IRQ 35
ncr53c8xx: 53c720 detected
ncr53c720-0: ID 7, Fast-10, Parity Checking, Differential
scsi0 : ncr53c8xx-3.4.3b-20010512
Vendor: SEAGATE Model: ST32171W Rev: HP03
Type: Direct-Access ANSI SCSI revision: 02
53c700: Version 2.6 By James.Bottomley@HansenPartnership.com
scsi1: 53c710 rev 2
scsi1 : LASI SCSI 53c700
scsi1: (2:0) Synchronous at offset 8, period 100ns
Vendor: TOSHIBA Model: CD-ROM XM-5701TA Rev: 1347
Type: CD-ROM ANSI SCSI revision: 02
Attached scsi disk sda at scsi0, channel 0, id 6, lun 0
ncr53c720-0-<6,*>: FAST-10 WIDE SCSI 20.0 MB/s (100 ns, offset 8)
SCSI device sda: 4194685 512-byte hdwr sectors (2148 MB)
Partition check:
sda: sda1 sda2 sda3
Attached scsi CD-ROM sr0 at scsi1, channel 0, id 2, lun 0
sr0: scsi-1 drive
Uniform CD-ROM driver Revision: 3.12
Lasi Harmony Audio driver V0.9a, h/w id 20, rev. 0 at 0xffd04000, IRQ 82
sticonsole_init: searching for STI ROMs
md: linear personality registered as nr 1
md: raid0 personality registered as nr 2
md: raid1 personality registered as nr 3
md: raid5 personality registered as nr 4
raid5: measuring checksumming speed
8regs : 142.000 MB/sec
8regs_prefetch: 142.000 MB/sec
32regs : 198.000 MB/sec
32regs_prefetch: 198.000 MB/sec
raid5: using function: 32regs_prefetch (198.000 MB/sec)
md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 8192 bind 16384)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
VFS: Mounted root (ext2 filesystem) readonly.
NOT FREEING INITMEM (383k)
Adding Swap: 124584k swap-space (priority -1)
eth0: link ok.
do_page_fault() pid=321 command='mozilla-bin' type=15 address=0x00000000
YZrvWESTHLNXBCVMcbcbcbcbOGFRQPDI
PSW: 00000000000001101111111100001111 Not tainted
r00-03 00000000 4024addf 417273cb 417412d8
r04-07 002247f0 bff010d0 bff010d0 42868564
r08-11 00000001 429c0e8a 00000006 00000013
r12-15 00000012 429c0e8a 42868422 00000000
r16-19 000b82b6 000b2248 00000000 417412d8
r20-23 4287b9e8 401b0aec 42869eb4 0000000f
r24-27 000a1ca8 00000000 00000000 0005e898
r28-31 003b92a0 003df978 bff01140 401b0b2f
sr0-3 00000148 00000148 00000000 00000148
sr4-7 00000148 00000148 00000148 00000148
IASQ: 00000148 00000148 IAOQ: 417273df 417273e3
IIR: 0f401094 ISR: 00000148 IOR: 00000000
CPU: 0 CR30: 14fc4000 CR31: 103a0000
ORIG_R28: 00000000
msieux01:~#
Reply to: