Re: Réseau avec une carte 3Com PCMCIA 575CT
Bonjour,
Sujet : Probleme de carte PCMCIA HS
Acces reseau ne fonctionne pas....
message : transmit time out, tx_status 00 status e201
eth0: Interrupt posted but not delivered -- IRQ blocked by another device ?
> On Thursday 13 January 2000, at 14 h 0, the keyboard of Laurent RENAULT
> <laurent.renault@u-picardie.fr> wrote:
>
> > eth0: Interrupt posted but not delivered -- IRQ blocked by another device ?
>
> Alors, dans l'ordre :
>
> - que dit 'dmesg' ?
> - que contient '/var/run/stab' ?
> - que dit 'ifconfig' ?
> - que contient '/proc/pci' (pour voir le contrôleur PCMCIA) ?
> - que contient '/proc/interrupts' ?
>
dmesg dit:
+++++++++
Linux version 2.2.14 (root@jfm-port) (gcc version 2.7.2.3) #1 Tue Jan 11 10:50:41 CET 2000
Detected 331585371 Hz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 330.96 BogoMIPS
Memory: 63548k/65472k available (660k kernel code, 416k reserved, 812k data, 36k init)
Dentry hash table entries: 8192 (order 4, 64k)
Buffer cache hash table entries: 65536 (order 6, 256k)
Page cache hash table entries: 16384 (order 4, 64k)
CPU: Intel Celeron (Mendocino) stepping 0a
Checking 386/387 coupling... OK, FPU using exception 16 error reporting.
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
PCI: PCI BIOS revision 2.10 entry at 0xfd9be
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Enabling memory for device 00:40
PCI: Enabling I/O for device 00:48
Linux NET4.0 for Linux 2.2
Based upon Swansea University Computer Society NET3.039
NET4: Unix domain sockets 1.0 for Linux NET4.0.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
TCP: Hash tables configured (ehash 65536 bhash 65536)
Starting kswapd v 1.5
apm: BIOS version 1.2 Flags 0x03 (Driver version 1.9)
PIIX4: IDE controller on PCI bus 00 dev 39
PIIX4: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xfcf0-0xfcf7, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0xfcf8-0xfcff, BIOS settings: hdc:pio, hdd:pio
hda: TOSHIBA MK6412MAT, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: TOSHIBA MK6412MAT, 6194MB w/0kB Cache, CHS=789/255/63, UDMA
Floppy drive(s): fd0 is 1.44M
floppy0: no floppy controllers found
Partition check:
hda: hda1 hda2 hda3 hda4
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 36k freed
Adding Swap: 64256k swap-space (priority -1)
Linux PCMCIA Card Services 3.1.8
kernel build: 2.2.14 #1 Tue Jan 11 10:50:41 CET 2000
options: [pci] [cardbus] [apm]
ds: no socket drivers loaded!
unloading PCMCIA Card Services
Serial driver version 4.27 with no serial options enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS02 at 0x03e8 (irq = 4) is a 8250
Linux PCMCIA Card Services 3.1.8
kernel build: 2.2.14 #1 Tue Jan 11 10:50:41 CET 2000
options: [pci] [cardbus] [apm]
Intel PCIC probe:
Ricoh RL5C475 PCI-to-CardBus at bus 0 slot 12, mem 0x68000000, 1 socket
host opts [0]: [serial irq] [io 3/6/1] [mem 3/6/1] [no pci irq] [lat 168/176] [bus 32/34]
ISA irqs (default) = 4,5,7,10,11,12,15 polling interval = 1000 ms
cs: IO port probe 0x1000-0x17ff: excluding 0x1040-0x104f
cs: IO port probe 0x0100-0x04ff: excluding 0x170-0x177 0x220-0x22f 0x330-0x337 0x370-0x37f 0x388-0x38f 0x398-0x39f 0x4d0-0x4d7
cs: IO port probe 0x0a00-0x0aff: clean.
cs: cb_alloc(bus 32): vendor 0x10b7, device 0x5257
3c59x.c:v0.99L 5/28/99 Donald Becker http://cesdis.gsfc.nasa.gov/linux/drivers/vortex.html
cs: cb_config(bus 32)
fn 0 bar 1: io 0x280-0x2ff
fn 0 bar 2: mem 0xa0021000-0xa002107f
fn 0 bar 3: mem 0xa0020000-0xa002007f
fn 0 rom: mem 0xa0000000-0xa001ffff
cs: cb_enable(bus 32)
bridge io map 0 (flags 0x21): 0x280-0x2ff
bridge mem map 0 (flags 0x1): 0xa0000000-0xa0021fff
vortex_attach(bus 32, function 0, device 5257)
eth0: 3Com 3CCFE575CT Cyclone CardBus at 0x280, 00:00:86:3f:7f:8c, IRQ 5
eth0: CardBus functions mapped a0020000->c4041000
8K byte-wide RAM 5:3 Rx:Tx split, MII interface.
MII transceiver found at address 0, status 7809.
Enabling bus-master transmits and whole-frame receives.
/var/run/ contient cardmgr.pid ainsi que d'autre deamon.pid....
ifconfig:
+++++++++
eth0 Link encap:Ethernet HWaddr 00:00:86:3F:7F:8C
inet addr:194.57.112.121 Bcast:194.57.112.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:294 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
Collisions:0
Interrupt:5 Base address:0x280
/proc/pci:
++++++++++
PCI devices found:
Bus 32, device 0, function 0:
Ethernet controller: 3Com Unknown device (rev 16).
Vendor id=10b7. Device id=5257.
Medium devsel. IRQ 5.
I/O at 0x280 [0x281].
Non-prefetchable 32 bit memory at 0xa0021000 [0xa0021000].
Non-prefetchable 32 bit memory at 0xa0020000 [0xa0020000].
Bus 0, device 0, function 0:
Host bridge: Intel 440BX - 82443BX Host (no AGP) (rev 3).
Medium devsel. Master Capable. Latency=64.
Prefetchable 32 bit memory at 0x0 [0x8].
Bus 0, device 7, function 0:
ISA bridge: Intel 82371AB PIIX4 ISA (rev 2).
Medium devsel. Fast back-to-back capable. Master Capable. No bursts.
Bus 0, device 7, function 1:
IDE interface: Intel 82371AB PIIX4 IDE (rev 1).
Medium devsel. Fast back-to-back capable. Master Capable. Latency=64.
I/O at 0xfcf0 [0xfcf1].
Bus 0, device 7, function 2:
USB Controller: Intel 82371AB PIIX4 USB (rev 1).
Medium devsel. Fast back-to-back capable. Master Capable. Latency=64.
I/O at 0xfcc0 [0xfcc1].
Bus 0, device 7, function 3:
Bridge: Intel 82371AB PIIX4 ACPI (rev 3).
Medium devsel. Fast back-to-back capable.
Bus 0, device 8, function 0:
FireWire (IEEE 1394): Unknown vendor Unknown device (rev 2).
Vendor id=104d. Device id=8039.
Medium devsel. Master Capable. Latency=64. Min Gnt=4.Max Lat=4.
Non-prefetchable 32 bit memory at 0xfedff000 [0xfedff000].
Non-prefetchable 32 bit memory at 0xfedffc00 [0xfedffc00].
Bus 0, device 9, function 0:
Multimedia audio controller: Unknown vendor Unknown device (rev 2).
Vendor id=1073. Device id=10.
Medium devsel. IRQ 9. Master Capable. Latency=64. Min Gnt=5.Max Lat=25.
Non-prefetchable 32 bit memory at 0xfedf0000 [0xfedf0000].
I/O at 0xfc40 [0xfc41].
I/O at 0xfcec [0xfced].
Bus 0, device 10, function 0:
VGA compatible controller: Neomagic Unknown device (rev 32).
Vendor id=10c8. Device id=5.
Medium devsel. Fast back-to-back capable. IRQ 3. Master Capable. Latency=128. Min Gnt=16.Max Lat=255.
Prefetchable 32 bit memory at 0xfd000000 [0xfd000008].
Non-prefetchable 32 bit memory at 0xfe800000 [0xfe800000].
Non-prefetchable 32 bit memory at 0xfec00000 [0xfec00000].
Bus 0, device 12, function 0:
CardBus bridge: Ricoh Unknown device (rev 128).
Vendor id=1180. Device id=475.
Medium devsel. Master Capable. Latency=168. Min Gnt=128.Max Lat=7.
/proc/interrupts:
++++++++++++++++
CPU0
0: 34997 XT-PIC timer
1: 750 XT-PIC keyboard
2: 0 XT-PIC cascade
4: 6 XT-PIC serial
5: 0 XT-PIC eth0
13: 1 XT-PIC fpu
14: 1914 XT-PIC ide0
NMI: 0
Voila...
Reply to: