Configuration SCSI
Bonjour,
J'ai un serveur avec un disque SCSI interne et un lecteur de bande SCSI
externe.
Lorque je boot mon serveur, j'ai les informations suivantes :
<----------------------------------------------
(scsi0) <Adaptec AHA-294X Ultra2 SCSI host adapter> found at PCI 11/0
(scsi0) Wide Channel, SCSI ID=7, 32/255 SCBs
(scsi0) Downloading sequencer code... 407 instructions downloaded
sym53c416.c: Version 1.0.0
DC390: 0 adapters found
Failed initialization of WD-7000 SCSI card!
aec671x_detect:
scsi0 : Adaptec AHA274x/284x/294x (EISA/VLB/PCI-Fast SCSI) 5.1.13/3.2.4
<Adaptec AHA-294X Ultra2 SCSI host adapter>
scsi : 1 host.
Vendor: IBM Model: DDRS-39130D Rev: DC1B
Type: Direct-Access ANSI SCSI revision: 02
Detected scsi disk sda at scsi0, channel 0, id 4, lun 0
(scsi0:0:4:0) Synchronous at 40.0 Mbyte/sec, offset 15.
Vendor: SONY Model: SDT-9000 Rev: 0400
Type: Sequential-Access ANSI SCSI revision: 02
(scsi0:0:5:0) Synchronous at 10.0 Mbyte/sec, offset 15.
scsi : detected 1 SCSI disk total.
SCSI device sda: hdwr sector= 512 bytes. Sectors= 17850000 [8715 MB] [8.7
GB]
<----------------------------------------------
...
<----------------------------------------------
Detected scsi tape st0 at scsi0, channel 0, id 5, lun 0
st: Unloaded.
Detected scsi tape st0 at scsi0, channel 0, id 5, lun 0
st: Unloaded.
Detected scsi tape st0 at scsi0, channel 0, id 5, lun 0
st: Unloaded.
<----------------------------------------------
Questions :
Que signifie "Failed initialization of WD-7000 SCSI card!" ?
Que signifie les 6 dernières lignes ?
Jean-Alexandre
Reply to: