Re: dip/CSLIP trouble (again)
> > See if it works OK in non-compressed mode. I think the compression module
> > is buggy at the moment. That will probably go away once Simon, our new
> > kernel maintainer, is up to speed.
>
> It's a little less dain-bramaged, but it still doesn't work. It's just
> not executing ifconfig or route for some reason.
When R6 first came out I found exactly the same problem. If you compile
SLIP/CSLIP into the kernel but *dont* load the modules for it, it will be
fine. When image/source etc are updated (perhaps along with the boot
disks) it'll be ok... Until the SLIP will work, just not CSLIP.
Regards
...Karl
--
________________________
| PO Box 828 Office: (09)316-3036 Fax: (09)381-3909
|OWER INTERNET SERVICES Canning Bridge After Hours: 015-779-828
WA, 6153 Sales Support: sales@tower.com.au
Internet Service Providers
and Networking Solutions
Reply to: