Uploaded setserial 2.17-14 (sparc) to ftp-master
-----BEGIN PGP SIGNED MESSAGE-----
Format: 1.6
Date: Sat, 27 May 2000 17:45:48 +0100
Source: setserial
Binary: setserial
Architecture: sparc
Version: 2.17-14
Distribution: frozen unstable
Urgency: low
Maintainer: Debian SPARC Build Daemon <buildd@marcus.seva.net>
Description:
setserial - Controls configuration of serial ports.
Closes: 64703
Changes:
setserial (2.17-14) frozen unstable; urgency=low
.
* The module.conf entries for pre-remove of modules in kerneld
is a null operation, although previous releases of setserial makes
use of this function, in the hope that one day it actually works.
However, if you currently unload and then reload the serial.o module,
you lose all your serial configuration details until you run
/etc/init.d/setserial start
I have made a simple change to the configuration, so that failure of
pre-remove is detected, and the serial ports on a module reload are
reconfigured to the configuration present imediately after serial
configuration has completed.
This is not as good as pre-remove actually working, but is probably
sufficient for all but the most nit-picking people out there. If
you change your serial configuration a lot during a single boot session,
consider calling
/etc/init.d/setserial modsave
from cron every minute or two (or at least before a module autoclean
occurs).
(closes: #64703)
Files:
147b0947b4e7e39ffa4b48d2cdfd9f57 36904 base required setserial_2.17-14_sparc.deb
-----BEGIN PGP SIGNATURE-----
Version: 2.6.3a
Charset: noconv
iQCVAwUBOTOvwyo9WkFm9rsJAQHifgQAgbPjJy2QJ9m8MB4XEueBgIIRgyY8oEI2
NKjVicYdRfZfSBbzfVK0KlyJLtwnqDg6TRyYBRXR1dZcpI9G6XZ3WpZ8OwsUQpve
yMqtLJGQHqWvFlve03bhQrgJcwWuH3ckCW2uk74ceU2aoUowHjPg1fqvt7ttvobu
7V43IDeeWSg=
=Ggvz
-----END PGP SIGNATURE-----
Reply to: