Uploaded setserial 2.17-14 (powerpc) to samosa

[buildd@crack.them.org]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Format: 1.6
Date: Sat, 27 May 2000 17:45:48 +0100
Source: setserial
Binary: setserial
Architecture: powerpc
Version: 2.17-14
Distribution: frozen unstable
Urgency: low
Maintainer: PowerPC Build Daemon/Daniel Jacobowitz <buildd@crack.them.org>
Description: 
 setserial  - Controls configuration of serial ports.
Closes: 64703
Changes: 
 setserial (2.17-14) frozen unstable; urgency=low
 .
   * The module.conf entries for pre-remove of modules in kerneld
     is a null operation, although previous releases of setserial makes
     use of this function, in the hope that one day it actually works.
     However, if you currently unload and then reload the serial.o module,
     you lose all your serial configuration details until you run
     /etc/init.d/setserial start
     I have made a simple change to the configuration, so that failure of
     pre-remove is detected, and the serial ports on a module reload are
     reconfigured to the configuration present imediately after serial
     configuration has completed.
     This is not as good as pre-remove actually working, but is probably
     sufficient for all but the most nit-picking people out there. If
     you change your serial configuration a lot during a single boot session,
     consider calling
     /etc/init.d/setserial modsave
     from cron every minute or two (or at least before a module autoclean
     occurs).
     (closes: #64703)
Files: 
 8ce1b494ad447540a81ca4c2cc1f9cf3 34774 base required setserial_2.17-14_powerpc.deb
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.0.1 (GNU/Linux)
Comment: For info see http://www.gnupg.org

iD8DBQE5M1xCbgOPXuCjg3cRAqA6AKC13gSb/P5MmOf/Wxu+aa5aYxak2wCgg48k
jR3+9wgeNj7x1KhXkzhefr0=
=+17Y
-----END PGP SIGNATURE-----