Bug#983043: Failed to initialize GENET properly on RPI4 (arm64)
Package: installation-reports
Boot method: netboot
Image version: https://d-i.debian.org/daily-images/arm64/daily/netboot/debian-installer/arm64/linux
2021-02-18 02:07 26M
Date: 2021-02-18 14:05:00
Machine: RPi4
Processor:
Memory: 4GiB
Partitions:
Output of lspci -knn (or lspci -nn):
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot: [O]
Detect network card: [O]
Configure network: [E]
Detect media: [ ]
Load installer modules: [ ]
Detect hard drives: [ ]
Partition hard drives: [ ]
Install base system: [ ]
Clock/timezone setup: [ ]
User/password setup: [ ]
Install tasks: [ ]
Install boot loader: [ ]
Overall install: [E]
Comments/Problems:
RPi 4 with 4GiB Ram. System is netbooted using DNSMASQ, RPI-UEFI and iPXE.
Netboot Debian Installer for arm64 starts and fails at configuring the
genet ethernet card.
I have attempted to remove and reinstall the genet driver. No effect.
ip link show has the card identified as enabcm6e4ei0.
I can put an address on the card using ip addr add.
ip link set dev down works
ip link set dev up fails with SIOCSIFFLAGS: No such device
--
"Non sibi, sed patriae"
Reply to: