Package: installation-reports
Boot method: TFTP+USB.iso+ ttl pl2303+network
Image version:
https://d-i.debian.org/daily-images/armhf/daily/hd-media/hd-media.tar.gz https://cdimage.debian.org/cdimage/weekly-builds/armhf/iso-cd/debian-testing-armhf-xfce-CD-1.isoDate: 28.03.2018_01:50am msk
Machine: ---Orange pi zero h2---
Processor: 1.2 Ghz Quad Core H2+ ARM Cortex A7 CPU
Memory: 512 MB DDR3 SDRAM
Partitions: < вывод результата команды df -Tl; лучше таблицу разделов в необработанном (raw) виде>
Вывод результата команд lspci -knn и lspci -nn:
Base System Installation Checklist:
[O] = OK, [E] = Ошибка (описать подробности ниже), [ ] = не пробовал
Initial boot: [ ]
Detect network card: [ ]
Configure network: [ ]
Detect CD: [ ]
Load installer modules: [ ]
Detect hard drives: [ ]
Partition hard drives: [ ]
Install base system: [ ]
Clock/timezone setup: [ ]
User/password setup: [ ]
Install tasks: [ ]
Install boot loader: [ ]
Overall install: [ ]
Comments/Problems:
Installation went fine on the sdcard.
Installed on Orange piZERO <sun8i-h2-plus-orange-zero.db>.
Loading from the Sdcard does not occur.
======================================================================
U-Boot SPL 2017.09-armbian (Nov 22 2017 - 16:49:05)
DRAM: 512 MiB
Failed to set core voltage! Can't set CPU frequency
Trying to boot from MMC1
U-Boot 2017.09-armbian (Nov 22 2017 - 16:49:05 +0100) Allwinner Technology
CPU: Allwinner H3 (SUN8I 1680)
Model: Xunlong Orange Pi PC
DRAM: 512 MiB
MMC: SUNXI SD/MMC: 0
In: serial
Out: serial
Err: serial
Net: phy interface0
eth0: ethernet@1c30000
starting USB...
USB0: USB EHCI 1.00
USB1: USB OHCI 1.0
USB2: USB EHCI 1.00
USB3: USB OHCI 1.0
USB4: USB EHCI 1.00
USB5: USB OHCI 1.0
scanning bus 0 for devices... 2 USB Device(s) found
scanning bus 2 for devices... 1 USB Device(s) found
scanning bus 4 for devices... 1 USB Device(s) found
scanning usb for storage devices... 1 Storage Device(s) found
Autoboot in 1 seconds, press <Space> to stop
=> run mmc_boot
switch to partitions #0, OK
mmc0 is current device
** Bad device specification mmc -bootable **
Scanning mmc :1...
Found U-Boot script /boot.scr
2627 bytes read in 153 ms (16.6 KiB/s)
## Executing script at 43100000
Mainline u-boot / new-style environment detected.
4121088 bytes read in 511 ms (7.7 MiB/s)
** File not found /dtbs/4.14.0-3-armmp-lpae/sun8i-h3-orangepi-pc.dtb **
SCRIPT FAILED: continuing...
=> <INTERRUPT>
=>
=> bootz
Starting kernel ...
---Hangs no reaction---
======================================================================