Bug#839803: installation-reports: Stretch Alpha 7 and todays daily fails to boot on ReadyNAS2120
On Wed, Oct 05, 2016 at 10:09:30AM +0200, Uwe Kleine-König wrote:
> Hello again,
>
> On Wed, Oct 05, 2016 at 09:15:05AM +0200, Uwe Kleine-König wrote:
> > when booting the installer kernel + initramfs the kernel just hangs
> > after some time. Below is the complete boot log. After the last line the
> > machine doesn't react at all, neither on normal key presses nor on sysrq
> > stuff.
> >
> > There are messages about udevadm and systemd, so I don't think this is a
> > pure kernel problem. Also there are messages from kernel modules, so
> > userspace is there somehow.
> >
> > There are three initcalls that have the calling line but none for
> > return:
> > ehci_orion_init+0x0/0x60 [ehci_orion]
> > mvneta_driver_init+0x0/0x24 [mvneta]
> > xhci_pci_init+0x0/0x5c [xhci_pci]
>
> I found that when disabling the usb device in the device tree[1] it
> works fine (apart from USB not working).
Further into the installation the hard disks are not detected. This
seems to be a bootloader issue though. Here is a table of machine +
bootloader + Debian release which makes me believe this:
rn104 + vendor U-Boot + Jessie | works fine
rn104 + barebox + Jessie | fails to detect disks
rn104 + vendor U-Boot + Stretch | fails to boot, no output on console
rn104 + barebox + Stretch | fails to detect disks
rn2120 + vendor U-Boot + Jessie | works fine
rn2120 + barebox + Jessie | fails to detect disks
rn2120 + vendor U-Boot + Stretch | fails to boot, no output on console
rn2120 + barebox + Stretch | fails to detect disks
So we have:
- barebox somehow breaks detection of disks
- vendor U-Boot cannot load Stretch installer (or needs a different
setup than for jessie at least, I guess the culprit is that the
initrd is much bigger)
Best regards
Uwe
--
Pengutronix e.K. | Uwe Kleine-König |
Industrial Linux Solutions | http://www.pengutronix.de/ |
Reply to: