[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Bug#690527: marked as done (Not installed Rtl8188cus USB card )

Your message dated Sat, 31 Aug 2013 00:24:06 +0200
with message-id <201308310024.32985.holger@layer-acht.org>
and subject line dealing with old installation-reports
has caused the Debian Bug report #690527,
regarding Not installed Rtl8188cus USB card 
to be marked as done.

This means that you claim that the problem has been dealt with.
If this is not the case it is now your responsibility to reopen the
Bug report if necessary, and/or fix the problem forthwith.

(NB: If you are a system administrator and have no idea what this
message is talking about, this may indicate a serious mail system
misconfiguration somewhere. Please contact owner@bugs.debian.org
immediately.)


-- 
690527: http://bugs.debian.org/cgi-bin/bugreport.cgi?bug=690527
Debian Bug Tracking System
Contact owner@bugs.debian.org with problems
--- Begin Message --- 
Package: installation-reports

Boot method: <How did you boot the installer? CD? > Image version:debian squeeze 6 05 XFCE CD1  <Full URL to image you downloaded is best> Date: <15.09.2012l>

Machine: <Description of machine (Toshiba portege 7200)> Processor:p3 Memory:328 Partitions: <ext3 partition table is preferred>

Output of lspci -knn (or lspci -nn):

Base System Installation Checklist: [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it

Initial boot: [ ok] Detect network card: [ e] Configure network: [ e] Detect CD: [ok ] Load installer modules: [ ok] Detect hard drives: [ok ] Partition hard drives: [ ok] Install base system: [ok ] Clock/timezone setup: [ok ] User/password setup: [ok ] Install tasks: [ok ] Install boot loader: [ e] Overall install: [ e]

Comments/Problems:

<Description of the install, in prose, and any thoughts, comments and ideas you had during the initial install.>
It doesn't find my network Rtl8188cus USB adapter during install. In spite of after installation it counted in lsusb command. And after installation network don't work. So excuse me that I can't show lsusb output I written this bug-report from android phone . 
And when I try to install driver loaded from realtek site, I find that make is unknown command. After I installed make, it start compile, but end with error on first step. And I Don,t can installation driver and internet on this debian system.
Other partition of the HDD on this PC is Xubuntu, and same not find USB wi-fi during installation, but after installation I can compiled them by same make command. Makefile was the same as use for debian.

I Don,t have any idea why make doe'snt work in debian. I think I make all properly, because all  work in Хububtu ?
In the bug report, describe what the problem is, including the last visible kernel messages in the event of a kernel hang. Describe the steps that you did which broug

--- End Message ---
--- Begin Message --- 
Hi,

thank you for submitting installation reports, much appreciated.

I read through all the bugs mentioned here (and I'm sure they were read by 
several people at the time they were submitted) and am closing them now as/if
- they (finally) indicated success and/or
- I know from first hand experience that the functionality is working in 
Wheezy and/or
- they only contained very little information and/or
- they contained user errors and/or
- they were caused by broken hardware and/or
- they have been from a development phase where things were not stable and/or
- they are quite old (and thus likely fixed today) and/or
- moreinfo was asked and not given or
- they are wishlist but rather special + exotic and not have been acted on for 
years. (See http://blog.liw.fi/posts/wishlist-bugs/ why it's often useful to 
close wishlist bugs.)

If I've closed a bug incorrectly please do reply (it's easy to reopen and I'll 
do if requested) or just file a new one - thats often better, as the bug log 
will be clearer and shorter and not contain cruft.


cheers,
        Holger

Attachment: signature.asc
Description: This is a digitally signed message part.


--- End Message ---
Reply to: