[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Bug#704523: fixed IPv6 Configuration only in installer fails



On 2013-04-03 03:09, Ben Hutchings wrote:
Control: tag -1 unreproducible

On Wed, 2013-04-03 at 00:59 +0200, Samuel Thibault wrote:
Philipp Kolmann, le Tue 02 Apr 2013 13:33:23 +0200, a écrit :
On console 4 I see the following logmessage looping:

nc_v6_interface_configured(eth0, scope global)
Running ip addr show eth0 to look for address
ip line: 2: eth0:<BROADCAST,MULTICAST,UP,LOWER_UP>   mtu 1500 qd isc pfifo_fast qlen 1000
ip line:     link/ether 00:50:56:be:XX:XX brd ff:ff:ff:ff:ff:ff
ip line:     inet6 2001:629:1005:323:250:56ff:febe:XXXX/64 scope global dynamic
ip line:       valid_lft 2591972sec preffered_lft 604772sec
ip line:     inet6 2001:629:1005:323::161/64 scope global tentative flags 08
ip line:       valid_lft forever preffered_lft forever
ip line:     inet6 fe80::250:56ff:febe:XXXX/64 scope link
ip line:       valid_lft forever preffered_lft forever
And the tentative flag never disappears?  You should probably check why
that doesn't happen, as that's what netcfg is waiting for AIUI.
I just tested this configuration and as expected the tentative status
goes away after 2 seconds.

Your ip output includes 'flags 08' which corresponds to IFA_F_DADFAILED
(duplicate address detection failed).  Which means either someone else
is already using the address you selected, or else a switch is
reflecting the packets sent during DAD.

Sorry for bothering. I had the IPv6 Address already in use, but not pingable, so I thought it was not in use.

Everything works fine now.

thanks
Philipp


Reply to: