--- Begin Message ---
Package: installation-reports
INSTALL REPORT
Debian-installer-version: Sarge i386 beta 2, downloaded last week
uname -a: Linux squid 2.4.22-1-386 #9 Sat Oct 4 14:30:39 EST 2003 i686 GNU/Linux
Date: 21 Feb 2004 13:12:27
Method: Installed off CD and then used local apt-proxy which in turn grabbed
binaries off ISP mirror and mirror.aarnet.edu.au when required
Machine: Clone yum cha
Processor: Pentium III 600MHz powerbeast
Memory: 256M
Root Device: IDE, /dev/hda
Root Size/partition table:
hda1 1G ext3 /
hda2 1G swap swap
hda5 6G ext3 /usr
hda6 6G ext3 /var
hda7 6G ext3 /home
Output of lspci:
00:00.0 Host bridge: VIA Technologies, Inc. VT82C693A/694x [Apollo PRO133x] (rev 44)
00:01.0 PCI bridge: VIA Technologies, Inc. VT82C598/694x [Apollo MVP3/Pro133x AGP]
00:07.0 ISA bridge: VIA Technologies, Inc. VT82C596 ISA [Mobile South] (rev 23)
00:07.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT8233/A/C/VT8235 PIPC Bus Master IDE (rev 10)
00:07.2 USB Controller: VIA Technologies, Inc. USB (rev 11)
00:07.3 Host bridge: VIA Technologies, Inc. VT82C596 Power Management (rev 30)
00:08.0 Ethernet controller: Lite-On Communications Inc LNE100TX (rev 20)
01:00.0 VGA compatible controller: NVidia / SGS Thomson (Joint Venture) Riva128 (rev 21)
Base System Installation Checklist:
Initial boot worked: [O]
Configure network HW: [O]
Config network: [O]
Detect CD: [O]
Load installer modules: [O]
Detect hard drives: [O]
Partition hard drives: [O]
Create file systems: [O]
Mount partitions: [O]
Install base system: [O]
Install boot loader: [O]
Reboot: [O]
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Comments/Problems:
Well done dudes, much better than old ones. Now I know this file exists
I'll send you the sparc details too.
Something that throws me every time. Partition the drives then you do
the setup of the partitions (ext2/ext3/swap/leave). It picks up the old
partition type which is usually WinNT.
A wishlist, why does it ask me if I want ext2/ext3 on a partition of
type swap? It should only be choosing swap/leave alone.
Problem with apt sources config, I use manual setup and it gets the package
files right but then loops back to Edit/Cancel step for configuring
apt. I just Cancel then manually go to next step (which is select
packages).
Strangess too... I install new version of exim4 but then it asks me to
configure mail server in installer. It's clever enough to know I have
already done it so it goes to next step.
Install logs and other status info is available in /var/log/debian-installer/.
Once you have filled out this report, mail it to submit@bugs.debian.org.
--- End Message ---