Re: Areca ARC-1880-ix-16
Hi,
Henry Gunter <henryg@henryg.net> wrote:
> On 08/19/2011 01:01 PM, Holger Wansing wrote:
> > Hi,
> >
> > Henry Gunter<henryg@henryg.net> wrote:
> >
> >> I am trying to install onto a raid array, however my raid controller is
> >> not recognized by the debian-installer. After searching I found this "
> >> http://lists.debian.org/debian-boot/2011/02/msg00688.html". Follow-ups
> >> to this, stated that work was being done to produce an updated version
> >> of the installer using a kernel that had a driver for my controller.
> >> This was dated 19 Feb 2011, by Otavio Salvador. My question is has this
> >> version been released? If yes , how do I get it? I have searched and am
> >> unable to find it. If it has not been completed, is there an estimated
> >> release date? Or is there a work around?
> >>
> > Maybe you can try one of these:
> >
> > http://kmuto.jp/b.cgi/debian/d-i-2639-squeeze.htm
> >
> > Note that these aren't official debian images.
> >
> >
> > Holger
> >
> >
>
> Hello again
> I finally fount time to test the install. Install went fine, the system
> is up and running on the Areca ARC-1880-ix-16 array. However every 5
> minutes I get Every 5 minutes in daemon.log:"init: Id "co" respawning
> too fast: disabled for 5 minutes". when searching I found this
> "http://bugs.debian.org/cgi-bin/bugreport.cgi?bug=636846", but no real
> advice on correcting the issue.
So you managed to install Squeeze via the images from
http://kmuto.jp/b.cgi/debian/d-i-2639-squeeze.htm
For further problems I forwarded this to the debian-boot list.
You may sent additional info to the bugreport you mentioned.
Holger
--
= = = = = = = = = = = = = = = = = = = = = = = = = = = = = = =
Created with Sylpheed 3.0.2
under DEBIAN GNU/LINUX 6.0 - S q u e e z e
Registered LinuxUser #311290 - http://counter.li.org/
= = = = = = = = = = = = = = = = = = = = = = = = = = = = = = =
Reply to: