Package:
installation-reports
Boot
method: <How did you boot the installer? CD? floppy? network?> CD
Image
version: <Full URL to image you downloaded is best> Lenny beta 2
Date:
<Date and time of the install> 11/27/08 14:57
Machine:
<Description of machine (eg, IBM Thinkpad R32)> My PC
Processor:
AMD4000+ ATHLON 64
Memory:
2 GB DDR400 KINGSTON
Partitions:
<df -Tl will do; the raw partition table is preferred>
Output
of lspci -knn (or lspci -nn):
Base
System Installation Checklist:
[O]
= OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial
boot: [O]
Detect
network card: [O]
Configure
network: [O]
Detect
CD:
[O]
Load
installer modules: [O]
Detect
hard drives: [E]
Partition
hard drives: [E]
Install
base system: [ ]
Clock/timezone
setup: [ ]
User/password
setup: [ ]
Install
tasks: [ ]
Install
boot loader: [ ]
Overall
install: [ ]
Comments/Problems:
<Description
of the install, in prose, and any thoughts, comments
and ideas you had during the initial install.>
I
set up a dmraid=true parameter in my install to detect my nvidia nforce4 raid 0
striping, I have 2 sata disk, each one 80 gb, when installs comes to detect array
/ partition part it shows the 2 80 gb’s disk but not my array (160 gb)
and it not show my 3 existing partitions