--- Begin Message ---
Package: installation-reports
Debian-installer-version:
daily build downloaded 03/03/05
uname -a: Linux safax01 2.4.27-2-386 #1 Thu Jan 20 10:55:08 JST 2005 i686
GNU/Linux
Date: 03/03/05 13:00 MET
Method: install via serial console
Machine: Intel SR1325 Server,
Processor: 3.0Ghz Pentium HT
Memory: 512MB
Root Device: /dev/md0, IDE
Root Size/partition table:
/dev/hda 160GB
primary part 0 512MB swap
primary part 1 50MB
primary part 2 100GB
primary part 3 49,5GB
/dev/hdb 160GB
primary part 0 512MB swap
primary part 1 50MB
primary part 2 100GB
primary part 3 49,5GB
created /dev/md0 with /dev/hda1 and /dev/hdb1 as /boot with ext2fs created
/dev/md1 with /dev/hda2 and /dev/hdb2 as / with ext3fs
created /dev/md2 with /dev/hda3 and /dev/hdb3 as /var with ext3fs
Output of lspci and lspci -n: n/a
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot worked: [O]
Configure network HW: [O]
Config network: [O]
Detect CD: [O]
Load installer modules: [O]
Detect hard drives: [O]
Partition hard drives: [E]
Create file systems: [O]
Mount partitions: [O]
Install base system: [O]
Install boot loader: [O]
Reboot: [O]
Comments/Problems:
The system was reinstalled with a daily build iso after trouble with the
RC2 installer (grub not correctly configured, system not bootable).
Harddrive hda had been configured to work as main drive when running the
daily build installer (after the initial RC2 install went wrong, i
installed the machine without raid to see if it was working):
hda1 was swap, hda2 /boot, hda3 / and hda4 /var.
hdb had still been configured for raid use with
hdb1 as swap, hdb2 raid, hdb3 raid, hdb4 raid
The partitioner showed three raid devices that were still active from the
first installation /md0 (member hdb2), /md1 (member hdb3), /md2 (member
hdb4).
I deleted the raid devices with the raid manager. Repartitioned both
harddrives to each have a swap and 3 data partitions for raid usage.
When I entered the Raid manager again after repartitioning to create raid
devices, it showed the raids to be still existing, although the raids were
deleted before and did not show up in the main partitioning screen! I had
to again delete all raid devices and create new raid devices without
leaving the raid manager to make it work. It seems like the raid manager
might be not writing the configuration correctly...
Cheers
Morten
--- End Message ---