Bug#563130: installation-reports 5.0.3 failure
Package: installation-reports
Boot method: <How did you boot the installer? CD?
cd
Image version: <Full URL to image you downloaded is best>
latest stable netiso off www.debian.org.
http://www.debian.org/CD/http-ftp/#stable
Date: <Date and time of the install>
NZST 5.26pm
Machine: <Description of machine (eg, IBM Thinkpad R32)> Whitebox Asus P5K premium motherboard, works fine on Debian 4.0
Processor: dual core 1.6ghz celeron
Memory: 2.5Gb
Partitions: <df -Tl will do; the raw partition table is preferred>
Output of lspci -knn (or lspci -nn):
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot: [0]
Detect network card: [0]
Configure network: [0]
Detect CD: [0]
Load installer modules: [0]
Detect hard drives: [x]
Partition hard drives: [ ]
Install base system: [ ]
Clock/timezone setup: [ ]
User/password setup: [ ]
Install tasks: [ ]
Install boot loader: [ ]
Overall install: [ ]
Comments/Problems:
<Description of the install, in prose, and any thoughts, comments
and ideas you had during the initial install.>
Took a working Debian 4.0 system and did a fresh install of Debian 5.0.3 via netinstall cd.
Attempted to install to PERC3 raid PCI device, this worked on Debian 4.0 but wont detect on 5.0.3.
attempted to install the megaraid_mbox module manually, no success.
Tried an adaptec raid controller type "I20" 2100S this also failed in disk detection, tried to load i2o module manually, this also failed.
It appears to be compatible,
http://i2o.shadowconnect.com/
Unable to proceed.
regards
Steven
Reply to: