Re: usb stick does not mount
* Joakim Seeberg <privat@seebergit.dk> [2008-11-16 21:55]:
>> sdi: assuming drive cache: write through
>> sdi:<3>Buffer I/O error on device sdi, logical block 0
>> Buffer I/O error on device sdi, logical block 0
>> ldm_validate_partition_table(): Disk read failed.
>> Buffer I/O error on device sdi, logical block 0
>> unable to read partition table
>> sdi : READ CAPACITY failed.
>> sdi : status=0, message=00, host=7, driver=00
>>
>>
> Just tried to format the stick with ext2 but that did not help and dmesg
> looks the same
OK, this is obviously a problem with the QNAP firmware (assuming the
USB stick works on another system). We can only help you with Debian,
not with the QNAP firmware. So I suggest you report this to
http://forum.qnap.com/
--
Martin Michlmayr
http://www.cyrius.com/
Reply to: