Bug#404951: Problem still exists in rc2 (was: Installation Report [mips] [daily-2006-12-27] [Failure] SWARM (Broadcom BCM91250a))
The problem (kernel does not start on SWARM) still exists in d-i rc2,
downloaded on 2007/03/23 from
http://ftp.nl.debian.org/debian/dists/testing/main/installer-mips/current/images/sb1-bcm91250a/netboot/
Boot log is as follows:
CFE> boot -tftp 192.168.2.14:/tftpboot/swarm-rc2/sibyl
Loader:raw Filesys:tftp Dev:eth0 File:192.168.2.14:/tftpboot/swarm-rc2/sibyl
Options:(null)
Loading: ....... 130116 bytes read
Entry at 0x0000000020000000
Closing network.
Starting program at 0x0000000020000000
SiByte Loader, version 2.4.2
Built on Oct 4 2005
Network device 'eth0' configured
Getting configuration file
tftp:192.168.2.14:/tftpboot/swarm-rc2/sibyl.conf...
Config file retrieved.
Available configurations:
install
rescue
Boot which configuration [install]:
Loading kernel (ELF64):
4391624@0x80100000
done
Loading ramdisk at 0x8057e000...3868329 bytes loaded
Set up command line arguments to: root=/dev/ram console=duart0
ramdisk_size=3816 rd_start=0x8057E000 rd_size=0x3B06A9
Setting up initial prom_init arguments
Cleaning up state...
Transferring control to the kernel.
Kernel entry point is at 0x804f7000
Broadcom SiByte BCM1250 B2 @ 800 MHz (SB1 rev 2)
Board type: SiByte BCM91250A (SWARM)
After that, the system starts CFE again.
Regards,
Karsten
--
#include <standard_disclaimer>
Nach Paragraph 28 Abs. 3 Bundesdatenschutzgesetz widerspreche ich der Nutzung
oder Uebermittlung meiner Daten fuer Werbezwecke oder fuer die Markt- oder
Meinungsforschung.
Reply to: