Bug#404951: Installation Report [mips] [daily-2006-12-27] [Failure] SWARM (Broadcom BCM91250a)
Package: installation-reports
Severity: grave
Boot method: netboot
Image version: daily build 2006-12-27,
http://people.debian.org/~ths/d-i/mips/images/daily/sb1-bcm91250a/netboot/
Date: 2006-12-29
Machine: Broadcom BCM91250a "SWARM", mips/big-endian mode,
256MB RAM, serial console, IDE disk
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot: [E]
Detect network card: [ ]
Configure network: [ ]
Detect CD: [ ]
Load installer modules: [ ]
Detect hard drives: [ ]
Partition hard drives: [ ]
Install base system: [ ]
Clock/timezone setup: [ ]
User/password setup: [ ]
Install tasks: [ ]
Install boot loader: [ ]
Overall install: [ ]
Comments/Problems:
==================
Sibyl (the bootloader) starts, loads the kernel and the initrd,
jumps into the kernel and the system freezes.
Boot log:
=========
CFE> boot -tftp 192.168.2.14:/tftpboot/swarm-daily/sibyl
Loader:raw Filesys:tftp Dev:eth0
File:192.168.2.14:/tftpboot/swarm-daily/sibyl Options:(null)
Loading: ....... 130116 bytes read
Entry at 0x0000000020000000
Closing network.
Starting program at 0x0000000020000000
SiByte Loader, version 2.4.2
Built on Oct 4 2005
Network device 'eth0' configured
Getting configuration file
tftp:192.168.2.14:/tftpboot/swarm-daily/sibyl.conf...
Config file retrieved.
Available configurations:
install
rescue
Boot which configuration [install]:
Loading kernel (ELF64):
4391624@0x80100000
done
Loading ramdisk at 0x8057e000...3622876 bytes loaded
Set up command line arguments to: root=/dev/ram console=duart0
ramdisk_size=3576 rd_start=0x8057E000 rd_size=0x3747DC
Setting up initial prom_init arguments
Cleaning up state...
Transferring control to the kernel.
Kernel entry point is at 0x804f7000
Broadcom SiByte BCM1250 B2 @ 800 MHz (SB1 rev 2)
Board type: SiByte BCM91250A (SWARM)
Regards,
Karsten
--
#include <standard_disclaimer>
Nach Paragraph 28 Abs. 3 Bundesdatenschutzgesetz widerspreche ich der Nutzung
oder Uebermittlung meiner Daten fuer Werbezwecke oder fuer die Markt- oder
Meinungsforschung.
Reply to: