Bug#395886:

[Giorgio Pioda <gfwp@ticino.com>]

Package: installation-reports

Boot method: <How did you boot the installer? CD? floppy? network?>
Image version: <Fill in date and from where you got the image>
Date: <Date and time of the install>

Machine: <Description of machine (eg, IBM Thinkpad R32)>
Processor:
Memory:
Partitions: <df -Tl will do; the raw partition table is preferred>

Output of lspci and lspci -n:

Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it

Initial boot worked:    [O]
Configure network HW:   [E]
Config network:         [O]
Detect CD:              [O]
Load installer modules: [O]
Detect hard drives:     [O]
Partition hard drives:  [O]
Create file systems:    [O]
Mount partitions:       [O]
Install base system:    [O]
Install boot loader:    [O]
Reboot:                 [O]

Comments/Problems:

Multiple network card (Built in on a MSI K8N Neo4) detection is confused. The same card is detected as eth0, eth1 or eth2
upon subsequent install trials.