Bug#379120: Bug#379365: Semi-successful install with miBoot floppy set and Netinst CD on OldWorld Mac...
On Jul 23, 2006, at 1:49 PM, Rick Thomas wrote:
On Jul 23, 2006, at 6:58 AM, Geert Stappers wrote:
On Sun, Jul 23, 2006 at 02:14:26AM -0400, Rick Thomas wrote:
Installation on (OldWorld) PowerMac beige G3 (Gossamer) using miBoot
floppies and netinst CDrom.
| Debian etch daily powerpc netinst install CD iso dated "21-
Jul-2006 01:57 166MB"
Output of lspci and lspci -n:
debian:~# ( lspci -n ; lspci ) | sort
| 00:00.0 0600: 1057:0002 (rev 40)
| 00:00.0 Host bridge: Motorola MPC106 [Grackle] (rev 40)
| 00:0d.0 0200: 1186:1300 (rev 10)
| 00:0d.0 Ethernet controller: D-Link System Inc RTL8139 Ethernet
| 00:0e.0 0100: 1191:0009 (rev 06)
| 00:0e.0 SCSI storage controller: Artop Electronic Corp ATP865
Was "lspci" run in the installer or in the installed system?
If in the installer: Was it before installing the desktop task?
I'm asking because bugreport #379120 (Reply-To: is set accordingly )
It was run in the installed system.
As noted elsewhere, lspci is pulled in by the "Desktop" task. It's
not present in the "bare-bones" ("Desktop" un-checked) install (as
one might want to use for a simple server)
The reason that lspci is present here is that, post-install, I used
tasksel to load the "Desktop" task as part of a different experiment
reported on elsewhere.
I have not yet tried using lspci on a system during installation. Do
you need that test done?
Hope this helps!