--- Begin Message ---
Package: installation-reports
Boot method: Netinst CD
Image version: Beta1
Date: Thu Feb 21 00:00:00 CET 2006
Machine: Dell Inspiron 9400
Processor: Intel® CoreTM Duo Processor 1.66 GHz
Memory: 1GB
Partitions:
# fdisk -l /dev/sda
Disk /dev/sda: 100.0 GB, 100030242816 bytes
255 heads, 63 sectors/track, 12161 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Device Boot Start End Blocks Id System
/dev/sda1 1 2432 19535008+ b W95 FAT32
/dev/sda2 2433 11915 76172197+ 83 Linux
/dev/sda3 11916 12037 979965 82 Linux swap / Solaris
/dev/sda4 * 12038 12161 996030 83 Linux
# df -Tl
Filesystem Type 1K-blocks Used Available Use% Mounted on
/dev/sda2 reiserfs 76169828 1353224 74816604 2% /
/dev/sda4 ext3 933393 23261 860331 3% /boot
tmpfs tmpfs 517688 0 517688 0% /dev/shm
Output of lspci and lspci -n:
0000:00:00.0 Host bridge: Intel Corporation Mobile 945GM/PM/GMS/940GML
and 945GT
Express Memory Controller Hub (rev 03)
0000:00:01.0 PCI bridge: Intel Corporation Mobile 945GM/PM/GMS/940GML
and 945GT
Express PCI Express Root Port (rev 03)
0000:00:1b.0 Audio device: Intel Corporation 82801G (ICH7 Family) High
Definitio
n Audio Controller (rev 01)
0000:00:1c.0 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI
Express Port
1 (rev 01)
0000:00:1c.1 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI
Express Port
2 (rev 01)
0000:00:1c.3 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI
Express Port
4 (rev 01)
0000:00:1d.0 USB Controller: Intel Corporation 82801G (ICH7 Family) USB
UHCI #1
(rev 01)
0000:00:1d.1 USB Controller: Intel Corporation 82801G (ICH7 Family) USB
UHCI #2
(rev 01)
0000:00:1d.2 USB Controller: Intel Corporation 82801G (ICH7 Family) USB
UHCI #3
(rev 01)
0000:00:1d.3 USB Controller: Intel Corporation 82801G (ICH7 Family) USB
UHCI #4
(rev 01)
0000:00:1d.7 USB Controller: Intel Corporation 82801G (ICH7 Family) USB2
EHCI Co
ntroller (rev 01)
0000:00:1e.0 PCI bridge: Intel Corporation 82801 Mobile PCI Bridge (rev e1)
0000:00:1f.0 ISA bridge: Intel Corporation 82801GBM (ICH7-M) LPC
Interface Bridg
e (rev 01)
0000:00:1f.2 IDE interface: Intel Corporation 82801GBM/GHM (ICH7 Family)
Serial
ATA Storage Controller IDE (rev 01)
0000:00:1f.3 SMBus: Intel Corporation 82801G (ICH7 Family) SMBus
Controller (rev
01)
0000:01:00.0 VGA compatible controller: nVidia Corporation: Unknown
device 0098
(rev a1)
0000:03:00.0 Ethernet controller: Broadcom Corporation BCM4401-B0
100Base-TX (re
v 02)
0000:03:01.0 FireWire (IEEE 1394): Ricoh Co Ltd: Unknown device 0832
0000:03:01.1 0805: Ricoh Co Ltd R5C822 SD/SDIO/MMC/MS/MSPro Host Adapter
(rev 19
)
0000:03:01.2 System peripheral: Ricoh Co Ltd: Unknown device 0843 (rev 01)
0000:03:01.3 System peripheral: Ricoh Co Ltd R5C592 Memory Stick Bus
Host Adapte
r (rev 0a)
0000:03:01.4 System peripheral: Ricoh Co Ltd xD-Picture Card Controller
(rev 05)
0000:0c:00.0 Network controller: Intel Corporation: Unknown device 4222
(rev 02)
0000:00:00.0 0600: 8086:27a0 (rev 03)
0000:00:01.0 0604: 8086:27a1 (rev 03)
0000:00:1b.0 0403: 8086:27d8 (rev 01)
0000:00:1c.0 0604: 8086:27d0 (rev 01)
0000:00:1c.1 0604: 8086:27d2 (rev 01)
0000:00:1c.3 0604: 8086:27d6 (rev 01)
0000:00:1d.0 0c03: 8086:27c8 (rev 01)
0000:00:1d.1 0c03: 8086:27c9 (rev 01)
0000:00:1d.2 0c03: 8086:27ca (rev 01)
0000:00:1d.3 0c03: 8086:27cb (rev 01)
0000:00:1d.7 0c03: 8086:27cc (rev 01)
0000:00:1e.0 0604: 8086:2448 (rev e1)
0000:00:1f.0 0601: 8086:27b9 (rev 01)
0000:00:1f.2 0101: 8086:27c4 (rev 01)
0000:00:1f.3 0c05: 8086:27da (rev 01)
0000:01:00.0 0300: 10de:0098 (rev a1)
0000:03:00.0 0200: 14e4:170c (rev 02)
0000:03:01.0 0c00: 1180:0832
0000:03:01.1 0805: 1180:0822 (rev 19)
0000:03:01.2 0880: 1180:0843 (rev 01)
0000:03:01.3 0880: 1180:0592 (rev 0a)
0000:03:01.4 0880: 1180:0852 (rev 05)
0000:0c:00.0 0280: 8086:4222 (rev 02)
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot worked: [O]
Configure network HW: [O]
Config network: [O]
Detect CD: [E]
Load installer modules: [O]
Detect hard drives: [E]
Partition hard drives: [O]
Create file systems: [O]
Mount partitions: [O]
Install base system: [O]
Install boot loader: [O]
Reboot: [O]
Comments/Problems:
After booting on the netinst cd, it failed to detect the Hard Drive. To
get it to work, I had to load these modules: ata_piix libata sd_mod
Then the base system installed without incident. After a reboot, the CD
drive was not detected. I have not yet gotten it to be detected at all.
What I did was (before reboot):
Alt-F2 + Enter to activate second console:
mkdir /target/mirror
cd /cdrom
cp -a dists/ pool/ /target/mirror
(after reboot)
select /mirror as file: element for apt config
The Intel Wireless 3945 card is still not working, but my there are no
Linux drivers for it yet from http://ipw2100.sourceforge.net/
--
Peter Valdemar Mørch
http://www.morch.com
--- End Message ---
--- Begin Message ---
Quoting Christian Perrier (bubulle@debian.org):
> reassign 354056 discover1-data
> retitle 354056 Intel 82801GBM/GHM SATA controller not properly detected
> tags 354056 patch
> thanks
>
> > After booting on the netinst cd, it failed to detect the Hard Drive. To
> > get it to work, I had to load these modules: ata_piix libata sd_mod
>
>
> >From discover1-data list that's not a surprise as your SATA controller
> was not listed here.
>
> The attached patch should sove the issue...untested, though.
Steve pointed me on IRC that that ata_piix is a 2.6 only module, so
this change should be made only in pci26.lst
Anyway, hardware detection no more uses discover1 with kernel 2.6 so
my comments are irrelevant here and there's nothing much we can do for
beta1 installs anymore
Closing the bug report as we should really focus on HW detection for
recent D-I images and there's an install report for the very same
machine and a daily build.
--- End Message ---