[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Bug#347378: HPPA Install error on HP C200



Package: installation-reports

Boot method: CD, current distribution of official netinst image and businesscard image
Image version: 2006-01-10
Date: 2006-01-09

Machine: HP C200
Processor: HP PA-RISC
Memory: 256MB
Partitions: One partition

Output of lspci and lspci -n: Impossibel to use this command

Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it

Initial boot worked:    [O ]
Configure network HW:   [O ]
Config network:         [ O]
Detect CD:              [O ]
Load installer modules: [O ]
Detect hard drives:     [O ]
Partition hard drives:  [O ]
Create file systems:    [ ]
Mount partitions:       [ ]
Install base system:    [E ]
Install boot loader:    [ ]
Reboot:                 [ ]

Comments/Problems:
 
While installation of base system I met the following error message.
.
Creating ext3 file system for / in partition #1 of SCSI1 (0,5,0)
(sda)...Kernel panic: drivers/parisc/ccio-dma.c: ccio_alloc_range() I/O MMU
is out of mapping resources.
In interrupt handler - not syncing
.
Friendly,
Nobel

 

DataTek                       정  기  용
Top in Data Protection                                        기술영업/이사

 

데이터텍주식회사
www.datatek.co.kr

서울 중구 만리동 KCC 파크타운 101-108호
Tel : 02-365-5766  Fax : 02-365-5765
Mobile : 016-390-5763
E-mail : kyjung@datatek.co.kr, support@datetek.co.kr


Reply to: