Bug#318194: Installation report
> Output of lspci and lspci -n:
Strange output actually. Is that with the new installed system. If
not, could you issue this again with the new installed system?
We need to find the PCI ID of the SATA controller and see if loading
ahci module for it would be relevant or not.
> -- Detect hard drives --
> SATA drives not detected. Sarge release install CD picks them up as
> legacy ATA drives (which doesn't really work.) The hardware detection
> did not locate them. After network install, was able to load them
> with modprobe ahci. Interestingly, the installer didn't notice that
> there were no hard drives and shows me some strange partitioning
> choices (with no drives available.) I know the sarge installer used
> to warn if there were no partitionable drives available. Going back
> through hardware detection worked around this issue (after manually
> loading the module).
Here, we might need to find out which new modules has been loaded
durign the second hardware detection run. Could you try to figure this
out by trying again (you can safely boot the installer again as long
as you go up to the partitioning menu) ?
Reply to: