Bug#311342: sarge RC3 finds "no partionable media" with 82801FBM SATA disk
Package: installation-reports
Version: Debian sarge net installation CD-ROM, built on 20050526
Problem: No partionable media were found.
I tried installation with several Debian CDs:
* "Sarge" - Official Snapshot i386 Binary-1 CD (20050423)
* sarge-rc3-i386-netinst (20050322)
* sarge-i386-netinst daily image (20050526)
always with the same problem.
Hardware: Sony Vaio VGN-S3XP (Notebook PC)
with IDE interface Intel 82801FBM (ICH6 Family)
and 80 GB SATA disk
Different boot options I tried:
boot: linux
boot: linux26 acpi=off vga=791
boot: expert26
Installation works well until the installer looks for
the hard disks:
----------------------------------------------------------
[!!] Partition disks
No partionable media
No partionable media were found.
Please check that a hard disk is attached to this machine.
----------------------------------------------------------
Booting with Knoppix 3.8, I find:
# lspci
0000:00:00.0 Host bridge: Intel Corp. Mobile Memory Controller Hub (rev 03)
0000:00:01.0 PCI bridge: Intel Corp. Mobile Memory Controller Hub PCI Express Port (rev 03)
0000:00:1b.0 0403: Intel Corp. 82801FB/FBM/FR/FW/FRW (ICH6 Family) High Definition Audio Controller (rev 03)
0000:00:1d.0 USB Controller: Intel Corp. 82801FB/FBM/FR/FW/FRW (ICH6 Family) USB UHCI #1 (rev 03)
0000:00:1d.1 USB Controller: Intel Corp. 82801FB/FBM/FR/FW/FRW (ICH6 Family) USB UHCI #2 (rev 03)
0000:00:1d.2 USB Controller: Intel Corp. 82801FB/FBM/FR/FW/FRW (ICH6 Family) USB UHCI #3 (rev 03)
0000:00:1d.3 USB Controller: Intel Corp. 82801FB/FBM/FR/FW/FRW (ICH6 Family) USB UHCI #4 (rev 03)
0000:00:1d.7 USB Controller: Intel Corp. 82801FB/FBM/FR/FW/FRW (ICH6 Family) USB2 EHCI Controller (rev 03)
0000:00:1e.0 PCI bridge: Intel Corp. 82801 PCI Bridge (rev d3)
0000:00:1f.0 ISA bridge: Intel Corp. 82801FBM (ICH6M) LPC Interface Bridge (rev 03)
0000:00:1f.1 IDE interface: Intel Corp. 82801FB/FBM/FR/FW/FRW (ICH6 Family) IDE Controller (rev 03)
0000:00:1f.2 IDE interface: Intel Corp. 82801FBM (ICH6M) SATA Controller (rev 03)
0000:00:1f.3 SMBus: Intel Corp. 82801FB/FBM/FR/FW/FRW (ICH6 Family) SMBus Controller (rev 03)
0000:01:00.0 VGA compatible controller: nVidia Corporation: Unknown device 0167 (rev a1)
0000:06:05.0 CardBus bridge: Texas Instruments PCI7420 CardBus Controller
0000:06:05.2 FireWire (IEEE 1394): Texas Instruments PCI7x20 1394a-2000 OHCI Two-Port PHY/Link-Layer Controller
0000:06:05.3 Unknown mass storage controller: Texas Instruments PCI7420/PCI7620 Dual Socket CardBus and Smart Card Cont. w/ 1394a-2000 OHCI Two-Port PHY/Link-Layer Cont. an
0000:06:08.0 Ethernet controller: Intel Corp.: Unknown device 1068 (rev 03)
0000:06:0b.0 Network controller: Intel Corp. PRO/Wireless 2200BG (rev 05)
# lspci -v
[...]
0000:00:1f.1 IDE interface: Intel Corp. 82801FB/FBM/FR/FW/FRW (ICH6 Family) IDE Controller (rev 03) (prog-if 8a [Master SecP PriP])
Subsystem: Sony Corporation: Unknown device 81b9
Flags: bus master, medium devsel, latency 0
I/O ports at <unassigned>
I/O ports at <unassigned>
I/O ports at <unassigned>
I/O ports at <unassigned>
I/O ports at 1880 [size=16]
0000:00:1f.2 IDE interface: Intel Corp. 82801FBM (ICH6M) SATA Controller (rev 03) (prog-if 8f [Master SecP SecO PriP PriO])
Subsystem: Sony Corporation: Unknown device 81ba
Flags: bus master, 66MHz, medium devsel, latency 0, IRQ 5
I/O ports at 18c0 [size=8]
I/O ports at 18b8 [size=4]
I/O ports at 18b0 [size=8]
I/O ports at 1894 [size=4]
I/O ports at 18a0 [size=16]
Memory at 80004400 (32-bit, non-prefetchable) [size=1K]
Capabilities: <available only to root>
[...]
# dmesg
Linux version 2.6.11 (root@Knoppix) (gcc-Version 3.3.5 (Debian 1:3.3.5-8)) #8 SMP Sun Mar 20 21:09:51 CET 2005
[...]
126MB HIGHMEM available.
896MB LOWMEM available.
[...]
DMI 2.3 present.
Built 1 zonelists
Kernel command line: ramdisk_size=100000 init=/etc/init lang=us apm=power-off vga=791 initrd=minirt.gz nomce quiet BOOT_IMAGE=knoppix BOOT_IMAGE=linux acpi=off
__iounmap: bad address c00fffd9
Found and enabled local APIC!
mapped APIC to ffffd000 (fee00000)
Initializing CPU#0
PID hash table entries: 4096 (order: 12, 65536 bytes)
Detected 798.187 MHz processor.
[...]
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ICH6: IDE controller at PCI slot 0000:00:1f.1
ICH6: chipset revision 3
ICH6: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0x1880-0x1887, BIOS settings: hda:DMA, hdb:pio
Probing IDE interface ide0...
hda: MATSHITAUJ-822Da, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
Probing IDE interface ide1...
Probing IDE interface ide2...
Probing IDE interface ide3...
Probing IDE interface ide4...
Probing IDE interface ide5...
hda: ATAPI 24X DVD-ROM DVD-R CD-R/RW drive, 2048kB Cache
Uniform CD-ROM driver Revision: 3.20
libata version 1.10 loaded.
ahci version 1.00
PCI: Setting latency timer of device 0000:00:1f.2 to 64
ahci(0000:00:1f.2) AHCI 0001.0000 32 slots 4 ports 1.5 Gbps 0x5 impl IDE mode
ahci(0000:00:1f.2) flags: 64bit ncq pm led pmp slum part
ata1: SATA max UDMA/133 cmd 0xF880E500 ctl 0x0 bmdma 0x0 irq 5
ata2: SATA max UDMA/133 cmd 0xF880E580 ctl 0x0 bmdma 0x0 irq 5
ata3: SATA max UDMA/133 cmd 0xF880E600 ctl 0x0 bmdma 0x0 irq 5
ata4: SATA max UDMA/133 cmd 0xF880E680 ctl 0x0 bmdma 0x0 irq 5
ata1: dev 0 cfg 49:2f00 82:346b 83:7f09 84:6063 85:3469 86:3f09 87:6063 88:203f
ata1: dev 0 ATA, max UDMA/100, 156301488 sectors: lba48
ata1: dev 0 configured for UDMA/100
scsi0 : ahci
ata2: no device found (phy stat 00000000)
scsi1 : ahci
ata3: no device found (phy stat 00000000)
scsi2 : ahci
ata4: no device found (phy stat 00000000)
scsi3 : ahci
Vendor: ATA Model: FUJITSU MHT2080B Rev: 4000
Type: Direct-Access ANSI SCSI revision: 05
SCSI device sda: 156301488 512-byte hdwr sectors (80026 MB)
SCSI device sda: drive cache: write back
SCSI device sda: 156301488 512-byte hdwr sectors (80026 MB)
SCSI device sda: drive cache: write back
sda: sda1 sda2 sda3 < sda5 sda6 >
Attached scsi disk sda at scsi0, channel 0, id 0, lun 0
[...]
Reply to: