Bug#309156: Adaptec ASC-39320(B) U320 w/HostRAID not detected
Package: installation-reports
I just forward this, in order to not loose this report.
Bye
Christian
-------- Original Message --------
Subject: installation-reports
Resent-Date: Sat, 7 May 2005 18:34:04 -0500 (CDT)
Resent-From: debian-boot@lists.debian.org
Date: Sun, 08 May 2005 01:11:48 +0200
From: Michel van der Klei <michel@mitch-it.com>
To: debian-boot@lists.debian.org
Package: installation-reports
Debian-installer-version:
http://cdimage.debian.org/pub/cdimage-testing/daily/
uname -a: nothing cause it got stuck in the installer
Date: May 6st
Method: Network install
Machine: Dell PowerEdge SC 1420
Processor: Xeon 2,8 HT
Memory: 512mb
Root Device: SCSI
Root Size/partition table: No HDD detected
Output of lspci and lspci -n:Not possible because of an install was not possible
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] =
didn't try it
Initial boot worked: [O]
Configure network HW: [O] (manualy added the e1000 module, not detected)
Config network: [O]
Detect CD: [O]
Load installer modules: [E] (Failure on the scsi controller)
Detect hard drives: [ ]
Partition hard drives: [ ]
Create file systems: [ ]
Mount partitions: [ ]
Install base system: [ ]
Install boot loader: [ ]
Reboot: [ ]
Comments/Problems:
Changed various settings on the scsi controller, bios enabled/disabled raid enabled disabled etc,
all without success. Tried an install with a 2.6 kernel, no success. Manually added the needed
modules (aic7xxx.0 and aacraid.o and tried aic79XXX aswell) without any success (with kernel 2.4 and 2.6)
Felt quitte desparated ;-) so i've installed the machine with the iso from the open-sourcelab
which comes with the Red Hat driver for this controller. This worked out fine but this is not
the way to go since this iso comes with a static kernel.This iso can be found on:
http://wiki.osuosl.org/display/LNX/Debian+on+Dell+Servers but ... it's woody based.
Advantage of the installation is that i can provide you with the out put of lspci and lspci -n
see below.
I'm gonna try to do some work with the sources form the adaptec site and udeb, but maybe there
are some folks over here who had this problem before ... so if so i'll be very gratefull.
output lspci and lspci -n
fs:~# lspci
0000:00:00.0 Host bridge: Intel Corp. Server Memory Controller Hub (rev 09)
0000:00:00.1 ff00: Intel Corp. Memory Controller Hub Error Reporting Register (rev 09)
0000:00:02.0 PCI bridge: Intel Corp. Memory Controller Hub PCI Express Port A0 (rev 09)
0000:00:03.0 PCI bridge: Intel Corp. Memory Controller Hub PCI Express Port A1 (rev 09)
0000:00:04.0 PCI bridge: Intel Corp. Memory Controller Hub PCI Express Port B0 (rev 09)
0000:00:1d.0 USB Controller: Intel Corp. 82801EB/ER (ICH5/ICH5R) USB UHCI #1 (rev 02)
0000:00:1d.1 USB Controller: Intel Corp. 82801EB/ER (ICH5/ICH5R) USB UHCI #2 (rev 02)
0000:00:1d.2 USB Controller: Intel Corp. 82801EB/ER (ICH5/ICH5R) USB UHCI #3 (rev 02)
0000:00:1d.3 USB Controller: Intel Corp. 82801EB/ER (ICH5/ICH5R) USB UHCI #4 (rev 02)
0000:00:1d.7 USB Controller: Intel Corp. 82801EB/ER (ICH5/ICH5R) USB2 EHCI Controller (rev 02)
0000:00:1e.0 PCI bridge: Intel Corp. 82801 PCI Bridge (rev c2)
0000:00:1f.0 ISA bridge: Intel Corp. 82801EB/ER (ICH5/ICH5R) LPC Bridge (rev 02)
0000:00:1f.1 IDE interface: Intel Corp. 82801EB/ER (ICH5/ICH5R) Ultra ATA 100 Storage Controller (rev 02)
0000:00:1f.2 IDE interface: Intel Corp. 82801EB (ICH5) Serial ATA 150 Storage Controller (rev 02)
0000:00:1f.3 SMBus: Intel Corp. 82801EB/ER (ICH5/ICH5R) SMBus Controller (rev 02)
0000:01:00.0 PCI bridge: Intel Corp. PCI Bridge Hub A
0000:01:00.2 PCI bridge: Intel Corp. PCI Bridge Hub B
0000:02:0c.0 VGA compatible controller: ATI Technologies Inc Rage XL (rev 27)
0000:03:0c.0 RAID bus controller: Adaptec ASC-39320(B) U320 w/HostRAID (rev 10)
0000:03:0c.1 RAID bus controller: Adaptec ASC-39320(B) U320 w/HostRAID (rev 10)
0000:03:0e.0 Ethernet controller: Intel Corp. 82545GM Gigabit Ethernet Controller (rev 04)
fs:~# lspci -n
0000:00:00.0 0600: 8086:3590 (rev 09)
0000:00:00.1 ff00: 8086:3591 (rev 09)
0000:00:02.0 0604: 8086:3595 (rev 09)
0000:00:03.0 0604: 8086:3596 (rev 09)
0000:00:04.0 0604: 8086:3597 (rev 09)
0000:00:1d.0 0c03: 8086:24d2 (rev 02)
0000:00:1d.1 0c03: 8086:24d4 (rev 02)
0000:00:1d.2 0c03: 8086:24d7 (rev 02)
0000:00:1d.3 0c03: 8086:24de (rev 02)
0000:00:1d.7 0c03: 8086:24dd (rev 02)
0000:00:1e.0 0604: 8086:244e (rev c2)
0000:00:1f.0 0601: 8086:24d0 (rev 02)
0000:00:1f.1 0101: 8086:24db (rev 02)
0000:00:1f.2 0101: 8086:24d1 (rev 02)
0000:00:1f.3 0c05: 8086:24d3 (rev 02)
0000:01:00.0 0604: 8086:0329
0000:01:00.2 0604: 8086:032a
0000:02:0c.0 0300: 1002:474f (rev 27)
0000:03:0c.0 0104: 9005:8095 (rev 10)
0000:03:0c.1 0104: 9005:8095 (rev 10)
0000:03:0e.0 0200: 8086:1026 (rev 04)
fs:~#
Kind Regards,
Michel van der Klei
--
To UNSUBSCRIBE, email to debian-boot-REQUEST@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
Reply to: