Bug#304565: (no subject)
Package: installation-reports
INSTALL REPORT
Debian-installer-version:
http://cdimage.debian.org/pub/cdimage-testing/sarge_d-i/alpha/rc3/sarge-alpha-businesscard.iso
uname -a: Linux alpha 2.4.27-2-generic #1 Sat Apr 9 19:43:25 UTC 2005 alpha GNU/Linux
Date: Wed Apr 13 21:44:20 EDT 2005
Method: Booted off of businesscard CD with a serial console, then
using network install with no proxy from mirrors.kernel.org.
Machine: COMPAQ AlphaServer DS10 466 MHz
Processor: Alpha EV6 466MHz
Memory: 512MB
Root Device: SCSI DEC Model: RZ28M
Root Size/partition table:
Filesystem 1K-blocks Used Available Use% Mounted on
/dev/sda3 1734322 492315 1149478 30% /
tmpfs 256416 0 256416 0% /dev/shm
/dev/sda2 73202 7616 61680 11% /boot
Output of lspci and lspci -n:
alpha:~# lspci
0000:00:01.0 USB Controller: ALi Corporation USB 1.1 Controller (rev 03)
0000:00:07.0 ISA bridge: ALi Corporation M1533 PCI to ISA Bridge [Aladdin IV] (rev c3)
0000:00:09.0 Ethernet controller: Digital Equipment Corporation DECchip 21142/43 (rev 41)
0000:00:0b.0 Ethernet controller: Digital Equipment Corporation DECchip 21142/43 (rev 41)
0000:00:0d.0 IDE interface: ALi Corporation M5229 IDE (rev c1)
0000:00:0e.0 VGA compatible controller: S3 Inc. 86c764/765 [Trio32/64/64V+]
0000:00:10.0 SCSI storage controller: LSI Logic / Symbios Logic 53c810 (rev 12)
alpha:~# lspci -n
0000:00:01.0 0c03: 10b9:5237 (rev 03)
0000:00:07.0 0601: 10b9:1533 (rev c3)
0000:00:09.0 0200: 1011:0019 (rev 41)
0000:00:0b.0 0200: 1011:0019 (rev 41)
0000:00:0d.0 0101: 10b9:5229 (rev c1)
0000:00:0e.0 0300: 5333:8811
0000:00:10.0 0100: 1000:0001 (rev 12)
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot worked: [O]
Configure network HW: [O]
Config network: [O]
Detect CD: [O]
Load installer modules: [O]
Detect hard drives: [O]
Partition hard drives: [O]
Create file systems: [O]
Mount partitions: [O]
Install base system: [O]
Install boot loader: [O]
Reboot: [O]
Comments/Problems:
Install went smooth even though I was using a serial console which I
thought might need some more work. Only thing that doesn't seem to
happen automatically is to have aboot.conf configured for serial
console so that when you reboot you need to be aware of this and
manually enter aboot and append console=ttyS0,9600 to the kernel
options. Once rebooted it's easy enough to edit
/etc/aboot.conf. /etc/inittab is however already setup for serial
console which is great !
Good job on the installer !
Reply to: