Bug#262387: hppa b180 success
Package: installation-reports
Debian-installer-version:
http://people.debian.org/~jbailey/d-i/hppa/daily/boot.img
uname -a: Linux caradhras 2.4.26-32-smp #1 SMP Sun Jun 20 20:45:33 CEST 2004 parisc GNU/Linux
Date: July 28, 2004.
Method: netboot from local tftpd
Machine: HP B180L+
Processor: Merlin L2+ 180 (9000/778/B180L) (0) at 0xfffbe000 [62], versions 0x504, 0x0, 0x4
Memory: 416M
Root Device: SCSI /dev/sda
Root Size/partition table:
Device Boot Start End Blocks Id System
/dev/sda1 1 31 31728 f0 Linux/PA-RISC boot
/dev/sda2 32 275 249856 82 Linux swap
/dev/sda3 * 276 1740 1500160 83 Linux
/dev/sda4 1741 4091 2407424 83 Linux
sda3 is /, sda4 is /home
Output of lspci:
kyle@caradhras:~$ lspci
0000:00:13.0 SCSI storage controller: LSI Logic / Symbios Logic 53c875 (rev 04)
0000:00:14.0 Ethernet controller: Digital Equipment Corporation DECchip 21142/43 (rev 41)
Base System Installation Checklist:
Initial boot worked: [O]
Configure network HW: [O]
Config network: [O]
Detect CD: [O]
Load installer modules: [O]
Detect hard drives: [O]
Partition hard drives: [O]
Create file systems: [O]
Mount partitions: [O]
Install base system: [O]
Install boot loader: [O]
Reboot: [O]
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Comments/Problems:
Worked fine, once again. Will try a cd install tomorrow.
System had mdetect installed, which tried to pull in read-edid,
which obviously didn't work.
Cheers,
--
Kyle McMartin
Reply to: