Bug#264506: all fine, but grub
Package: installation-reports
Debian-installer-version: Downloaded from http://http.us.debian.org/debian/dists/testing/main/installer-i386/rc1/images/netboot/pxeboot.tar.gz
thetis:/tftpboot# grep 200 debian-installer/boot-screens/f1.txt
This is a Debian installation netboot image, built on 20040801.
Installation run on 2004-08-09 0630 UTC, so whatever was on ftp.at.debian.org by then was it.
uname -a: 2.6.7-1-386 (in the installer)
Date: 2004-08-09 0630 UTC
Method: netboot, tftp. packages from the net vai a http proxy
Machine: Compaq ProLiant ML350
Processor: Xeon 2.8GHz
Memory: 1.5 GB
Root Device: hp smart array 641 (/dev/cciss/host0/target0/partNN, /dev/cciss/c0d0pNN)
Root Size/partition table:
hades:~# fdisk -l /dev/cciss/c0d0
Disk /dev/cciss/c0d0: 145.6 GB, 145667358720 bytes
255 heads, 32 sectors/track, 34866 cylinders
Units = cylinders of 8160 * 512 = 4177920 bytes
Device Boot Start End Blocks Id System
/dev/cciss/c0d0p1 * 1 60 244784 83 Linux
/dev/cciss/c0d0p2 61 419 1464720 83 Linux
/dev/cciss/c0d0p3 420 34866 140543760 5 Extended
/dev/cciss/c0d0p5 420 1137 2929424 82 Linux swap
/dev/cciss/c0d0p6 1138 34866 137614304 8e Linux LVM [ was setup manually ]
Output of lspci:
hades:~# lspci
0000:00:00.0 Host bridge: ServerWorks CMIC-LE Host Bridge (GC-LE chipset) (rev 33)
0000:00:00.1 Host bridge: ServerWorks CMIC-LE Host Bridge (GC-LE chipset)
0000:00:00.2 Host bridge: ServerWorks CMIC-LE Host Bridge (GC-LE chipset)
0000:00:02.0 SCSI storage controller: Adaptec AHA-3960D / AIC-7899A U160/m (rev 01)
0000:00:02.1 SCSI storage controller: Adaptec AHA-3960D / AIC-7899A U160/m (rev 01)
0000:00:03.0 VGA compatible controller: ATI Technologies Inc Rage XL (rev 27)
0000:00:04.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5702X Gigabit Ethernet (rev 02)
0000:00:05.0 System peripheral: Compaq Computer Corporation Advanced System Management Controller
0000:00:0f.0 ISA bridge: ServerWorks CSB5 South Bridge (rev 93)
0000:00:0f.1 IDE interface: ServerWorks CSB5 IDE Controller (rev 93)
0000:00:0f.2 USB Controller: ServerWorks OSB4/CSB5 OHCI USB Controller (rev 05)
0000:00:0f.3 Host bridge: ServerWorks CSB5 LPC bridge
0000:00:11.0 Host bridge: ServerWorks CIOB-X2 PCI-X I/O Bridge (rev 05)
0000:00:11.2 Host bridge: ServerWorks CIOB-X2 PCI-X I/O Bridge (rev 05)
0000:02:01.0 RAID bus controller: Compaq Computer Corporation Smart Array 64xx (rev 01)
Base System Installation Checklist:
Initial boot worked: [O]
Configure network HW: [O]
Config network: [O]
Detect CD: [ ]
Load installer modules: [O]
Detect hard drives: [O]
Partition hard drives: [O]
Create file systems: [O]
Mount partitions: [O]
Install base system: [O]
Install boot loader: [E]
Reboot: [ ]
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Comments/Problems:
Grub doesn't like the setup, and the error message one gets in the installer is
less than helpful:
| Unable to install GRUB in (hd0)
| Executing 'grub-install (hd0)' failed.
| This is a fatal error.
lilo works just fine.
/target # chroot .
sh-2.05b# grub-install '(hd0)'
The file /boot/grub/stage1 not read correctly.
sh-2.05b#
All in all, a great piece of Software that you built there. Thanks!
--
Peter
Reply to: