[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Bug#262387: hppa b180 success

Hello,

I've been trying to install sarge on a PA-RISC computer HP 712
But it failed with the partition process.

Hence my question is (as you said [O] it passed the partition process)
What exactly do you choose when partitioning  the  disk

Regards,
Laurent

Kyle McMartin wrote:


Package: installation-reports
Debian-installer-version: http://people.debian.org/~jbailey/d-i/hppa/daily/boot.img 
uname -a: Linux caradhras 2.4.26-32-smp #1 SMP Sun Jun 20 20:45:33 CEST 2004 parisc GNU/Linux
Date: July 28, 2004.
Method: netboot from local tftpd

Machine: HP B180L+
Processor: Merlin L2+ 180 (9000/778/B180L) (0) at 0xfffbe000 [62], versions 0x504, 0x0, 0x4
Memory: 416M
Root Device: SCSI /dev/sda
Root Size/partition table: 
  Device Boot      Start         End      Blocks   Id  System
/dev/sda1               1          31       31728   f0  Linux/PA-RISC boot
/dev/sda2              32         275      249856   82  Linux swap
/dev/sda3   *         276        1740     1500160   83  Linux
/dev/sda4            1741        4091     2407424   83  Linux

sda3 is /, sda4 is /home	

Output of lspci:

kyle@caradhras:~$ lspci
0000:00:13.0 SCSI storage controller: LSI Logic / Symbios Logic 53c875 (rev 04)
0000:00:14.0 Ethernet controller: Digital Equipment Corporation DECchip 21142/43 (rev 41)

Base System Installation Checklist:

Initial boot worked:    [O]
Configure network HW:   [O]
Config network:         [O]
Detect CD:              [O]
Load installer modules: [O]
Detect hard drives:     [O]
Partition hard drives:  [O]
Create file systems:    [O]
Mount partitions:       [O]
Install base system:    [O]
Install boot loader:    [O]
Reboot:                 [O]
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it

Comments/Problems:

	Worked fine, once again. Will try a cd install tomorrow.

	System had mdetect installed, which tried to pull in read-edid,
which obviously didn't work.

Cheers,
Reply to: