Bug#260127: installation-reports
Package: installation-reports
INSTALL REPORT
Debian-installer-version: 18.07.04
http://cdimage.debian.org/pub/cdimage-testing/sarge_d-i/i386/tc1/sarge-i386-businesscard.iso
uname -a: not possible,
Date: 18.07.04
Method: Installation over sarge businesscard tc1,CD-Rom, downloading from ftp.de.debian.org,no proxy
machine: amd k6-2 500mhz
Processor: amd k6-2 500mhz
Memory: 256mb-ram
Root Device: IDE
Root Size/partition table:
/dev/hdb1 487M 133M 328M 29% /mnt/hdb1
one partition no swap ext2
Output of lspci and lspci -n:
lspci:
00:00.0 Host bridge: VIA Technologies, Inc. VT82C598 [Apollo MVP3] (rev 04)
00:01.0 PCI bridge: VIA Technologies, Inc. VT82C598/694x [Apollo MVP3/Pro133x AGP]
00:07.0 ISA bridge: VIA Technologies, Inc. VT82C586/A/B PCI-to-ISA [Apollo VP] (rev 47)
00:07.1 IDE interface: VIA Technologies, Inc. Bus Master IDE (rev 06)
00:07.2 USB Controller: VIA Technologies, Inc. UHCI USB (rev 02)
00:07.3 Host bridge: VIA Technologies, Inc. VT82C586B ACPI (rev 10)
00:12.0 Ethernet controller: 3Com Corporation 3c905B 100BaseTX [Cyclone] (rev 30)
01:00.0 VGA compatible controller: nVidia Corporation GeForce 256 (rev 10)
lspci -n:
00:00.0 Class 0600: 1106:0598 (rev 04)
00:01.0 Class 0604: 1106:8598
00:07.0 Class 0601: 1106:0586 (rev 47)
00:07.1 Class 0101: 1106:0571 (rev 06)
00:07.2 Class 0c03: 1106:3038 (rev 02)
00:07.3 Class 0600: 1106:3040 (rev 10)
00:12.0 Class 0200: 10b7:9055 (rev 30)
01:00.0 Class 0300: 10de:0100 (rev 10)
Base System Installation Checklist:
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Initial boot worked: [O]
Configure network HW: [O]
Config network: [O]
Detect CD: [O]
Load installer modules: [O]
Detect hard drives: [O]
Partition hard drives: [O]
Create file systems: [O]
Mount partitions: [O]
Install base system: [O]
Install boot loader: [O]
Reboot: [E]
Comments/Problems:
Before this, I installed tc1 on the same machine on a 20gb-harddrive without any problems. After that I removed this harddrive and plugged an old 500mb-harddrive on ide0 slave. Masterdrive is not present.
CD-drive is on ide1 master.
After finishing the installation, it reboots, but reboots after pressing enter during the grub menu.
Same next reboot.
I filled out these log, by using knoppix.
____________________________________________________
Aufnehmen, abschicken, nah sein - So einfach ist
WEB.DE Video-Mail: http://freemail.web.de/?mc=021200
Reply to: