Latest sparc CD image fails
Hi,
I have just tried to boot my Sparcstation 10 from CD using the latest
sarge-sparc-businesscard.iso from [0] (just to make sure that it's the
right one, md5sum is 2d8db3d36a3010cd1b8194fbc38568eb). It fails with
kernel panic during the initial boot. The last screenful of messages is:
ESP: Total of 1 ESP hosts found, 1 actually in use.
scsi0 : Sparc ESP100A-FAST
Vendor: SEAGATE Model: ST1480 SUN0424 Rev: 7516
Type: Direct-Access ANSI SCSI revision: 02
Vendor: MATSHITA Model: CD-ROM CR-508 Rev: XS03
Type: CD-ROM ANSI SCSI revision: 02
Attached scsi disk sda at scsi0, channel 0, id 3, lun 0
esp0: target 3 [period 200ns offset 15 5.00MHz synchronous SCSI]
sda: Spinning up disk............ready
SCSI device sda: 843284 512-byte hdwr sectors (432 MB)
Partition check:
/dev/scsi/host0/bus0/target3/lun0: p1 p2 p3
Attached scsi CD-ROM sr0 at scsi0, channel 0, id 6, lun 0
esp0: target 6 asynchronous
sr0: scsi-1 drive
Uniform CD-ROM driver Revision: 3.12
Initializing Cryptographic API
NET4: Linux TCP/IP 1.0 for NET4.0
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 2048 bind 4096)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
RAMDISK: Compressed image found at block 0
Freeing initrd memory: 1193k freed
VFS: Mounted root (ext2 filesystem).
Mounted devfs on /dev
Kernel panic: VFS: Unable to mount root fs on 00:00
Press L1-A to return to the boot prom
[0] http://cdimage.debian.org/pub/cdimage-testing/sarge_d-i/sparc/20040427/
Best regards,
Jurij Smakov jurij@wooyd.org
Key: http://www.wooyd.org/pgpkey/ KeyID: C99E03CC
Reply to: