No network after install w/ realtek/8139too
This box is a small form factor Compaq deskpro w/ intel bx440 chipset 1-2.3G & 1-3.2G hdd's 400Mhz, 128M. I've ran the installer 3 times. The first 2 in expert the 3rd standard and it is the same each time. No network on reboot. This seems to be the culprit:
starting hotplug
failed
can't synthesize pci hotplug events
It also fails w/ usb hotplugging but I only see this on boot. dmesg doesn't mention it. I typed this relevent part of dmesg by hand so hopefully not any major errors.
PCI: Sharing IRQ 9 with 00:0a.0
usb-uhci.c: USB UHCI at I/O 0x2020, IRQ 9
usb-uhci.c: Detected 2 ports
usb.c new USB bus registered, assigned bus number 1
usb.c 2 ports detected
/snip/
PCI: Enabling device 00:0a.0 (0004 -> 0007)
PCI: Found IRQ 9 for device 00:0a.0
PCI: Sharing IRQ 9 with 00:14.2
eth0: OEM i82557/i82558 10/100 Ethernet, 00:08:C7:77:54:93, IRQ 9.
Receiver lock-up bug exists -- enabling work-around
Board assembly 307295-101, Physical connectors present: RJ45
Primary interface chip i82555 PHY #1
General self-test: passed
Serial sub-system self-test: passed
Internal registers self-test: passed
ROM checksum self-test: passed (0x24c9f043)
Receiver lock-up workaround activated
8139too Fast Ethernet driver 0.9.26
PCI: Found IRQ 11 for device 00:0d.0
eth1: RealTek RTL8139 at 0xc4880000, 00:02:2a:c4:6c:36, IRQ 11
eth1: Identified 8139 chip type 'RTL-8100B/8139d'
Reply to: