Bug#234979: Daily 20040219 - no big problems
Package: installation-reports
Debian-installer-version:
http://gluck.debian.org/cdimage/testing/daily/i386/20040219/sarge-i386-netinst.isouname -
a: Linux dopping 2.4.24-1-386 #3 Wed Feb 4 18:58:18 EST 2004 i686 GNU/Linux
Date: Thu Feb 26 17:25:04 EET 2004
Method: Boot from the cd mentioned above, install by just pressing enter
(default). Language english, location and keyboard layout FinnishMachine: HP
E-pc 10 (no Floppy)Processor: PIII 1GHz
Memory:256MB
Root Device: hda1Root Size/partition table:7.5G /dev/hda5 on / type ext3
(rw,errors=remount-ro) proc on /proc type proc (rw)40MB /dev/hda1 on
/boot type ext3 (rw) devpts on /dev/pts type devpts
(rw,gid=5,mode=620)128MB tmpfs on /dev/shm type tmpfs (rw) usbfs on
/proc/bus/usb type usbfs (rw)
Output of lspci:00:00.0 Host bridge: Intel Corp. 82810E DC-133 GMCH
[Graphics Memory Controller Hub] (rev 03)00:01.0 VGA compatible controller:
Intel Corp. 82810E DC-133 CGC [Chipset Graphics Controller] (rev 03)00:1e.0
PCI bridge: Intel Corp. 82801AA PCI Bridge (rev 02)00:1f.0 ISA bridge: Intel
Corp. 82801AA ISA Bridge (LPC) (rev 02)00:1f.1 IDE interface: Intel Corp.
82801AA IDE (rev 02)00:1f.2 USB Controller: Intel Corp. 82801AA USB (rev
02)00:1f.3 SMBus: Intel Corp. 82801AA SMBus (rev 02)00:1f.5 Multimedia audio
controller: Intel Corp. 82801AA AC'97 Audio (rev 02)01:02.0 Ethernet
controller: 3Com Corporation 3c905C-TX/TX-M [Tornado] (rev 78)
Base System Installation Checklist:
Initial boot worked: [O]
Configure network HW: [O]
Config network: [O]
Detect CD: [O]
Load installer modules: [E]
Detect hard drives: [O]
Partition hard drives: [O]
Create file systems: [O]
Mount partitions: [O]
Install base system: [E]
Install boot loader: [O]
Reboot: [O]
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Comments/Problems:
As the base-config ended, i.e. you get the login prompt the first time it
said on the top of the page:error: Should never end up here when using
'ANSI_X3.4-1968'Modules: In expert mode it tries again and again to install
the floppy modules, but fails and compains about it. Then the network module
doesn't load because it is seemingly stuck after the misloading floppy
module.PCMCIA: I liked the old installer, where the pcmcia-packets
automatically were removed at the dselect-run in the end of the install
process, if not used.Andreas Ehnbergantto@exxi.fi
Reply to: